Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 945
– Disconnect the connector -1-.
– Remove the connector lock in the direction of the -arrow B-
and press down.
– Disconnect the connector -2-.
– Push the connector lock in the direction of the -arrow C- and
disconnect the connector -3-.
– Push the release -1- on both sides in the direction of the
-arrow A-.
– Slightly remove the steering column switch module -2-.
– Push the release -3- in the direction of the -arrow B-.
– Remove the steering column switch module -2-.
Installing
Install in the reverse order of removal while paying attention to
the following:
– The following must be checked on the Steering Column Elec‐
tronics Control Module - J527- -3- before sliding on the steer‐
ing column switch module:
♦ The “arrows” -1- must align.
♦ The spiral spring -2- must be seen in the window between the
“arrows” -4-.
8.6
Steering Column Electronics Control
Module - J527- , Removing and Instal‐
ling
⇒ “8.6.1 Steering Column Electronics Control Module J527 , Re‐
moving and Installing, Kostal”, page 187
⇒ “8.6.2 Steering Column Electronics Control Module J527 , Re‐
moving and Installing, Valeo”, page 189
8.6.1
Steering Column Electronics Control
Module - J527- , Removing and Instal‐
ling, Kostal
The Airbag Spiral Spring/Return Spring with Slip Ring - F138- is
integrated into the Steering Column Electronics Control Module -
J527- .
If the control module is being replaced, use the Vehicle Diagnostic
Tester and select the “Replacing” function for the respective con‐
trol module in “Guided Fault Finding”.
Removing
– Position the front wheels straight-ahead. The steering wheel
is located in the neutral position.
– Position the steering wheel as far back as possible. Use the
entire adjustment range of the steering column adjustment for
this.
– Remove the steering wheel. Refer to ⇒ Suspension, Wheels,
Steering; Rep. Gr. 48 ; Steering Wheel; Steering Wheel, Re‐
moving and Installing .
– Remove the lower steering column trim panel. Refer to ⇒ Body
Interior; Rep. Gr. 68 ; Storage Compartments and Covers;
Lower Steering Column Trim Panel, Removing and Installing .
WARNING
Risk of destroying electronic components with static discharge.
♦ Before disconnecting the connector, discharge static elec‐
tricity from your body by touching a grounded vehicle
component such as the door striker pin.
– Push the connector lock in the direction of the -arrow A- and
disconnect the connector -1-.
– Push the connector lock in the direction of the -arrow B- and
disconnect the connector -2-.
– Push the connector lock in the direction of the -arrow C- and
disconnect the connector -3-.
– Remove the connector lock in the direction of the -arrow D-
and press down.
– Disconnect the connector -4-.
– Push the connector lock in the direction of the -arrow E- and
disconnect the connector -5-.
– Remove the connector lock in the direction of the -arrow F-
and press down.
– Disconnect the connector -6-.
– Remove the bolt -1-.
– Release the mounting tabs in the direction of the
-arrows A and B-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст