Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 276
– Insert the glass panel -1- from above in direction of
-a arrows- into the tilting mechanism -3-. Insert the screws
-2- but do not tighten.
– Adjust the front glass panel. Refer to
⇒ “1.8.2 Glass Panel, Adjusting, Wagon”, page 243
.
– Tighten the screws -2-.
– Install the trim -2- on the glass panel -1- and slide onto the
fasteners.
– After completing all work, perform an adaptation of the sunroof
motor. Refer to
⇒ “1.17 Power Sunroof Control Module J245 , Programming”,
.
Tightening Specifications
♦ Refer to
⇒ “1.2.3 Overview - Sunroof, Wagon”, page 199
1.7
Rear Sunroof Panel, Removing and In‐
stalling
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Removing
Note
When unscrewing the screws, use a magnetic tool so that the screws cannot fall into the panorama sunroof
guide.
– Remove the seal -3- from the assembly frame.
– Remove the left and right screws -2- from the glass panel
-1-.
– Slide the rear glass panel -1- slightly under the front glass
panel -3- in direction of -arrow a-.
– Lift the rear glass panel -1- only in the rear area off of the roof
opening -2- in direction of -arrows b-.
– Guide the rear glass panel -1- up at an angle in direction of
-arrow c- over the roof -2- and pull out from under the front
glass panel -3-.
Installing
Note
♦
New screws are always to be used when installing the glass panel.
♦
When installing the screws, use a magnetic tool so that the screws cannot fall into the panorama sliding
sunroof guide.
Install in reverse order of removal.
– Insert the rear glass panel -1- from above at an angle under
the front sunroof panel -3-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст