Volkswagen Golf Variant, Jetta. Manual — part 9
WARNING
Before working on vehicle with engine running, move selector
lever into position “P” and apply handbrake.
2.1
Overview - selector mechanism in vehicles up to 02.2009
Selector mechanism from 03.2009 onwards
⇒ page 41
.
1 - Selector cover with handle
❑ Do not remove handle
without reason. For
emergency release, on‐
ly the cover needs to be
unclipped
⇒ page 46
.
❑ Before removal of han‐
dle, pull lock button out
past its pressure point.
Secure locking button
with a cable tie or appro‐
priate wire against being
pressed in. This will pre‐
vent lock button from
being accidentally
pressed into the handle.
❑ Removing and installing
selector lever handle
⇒ page 46
2 - Selector mechanism with
selector lever
❑ With selector lever lock
solenoid -N110-
❑ Emergency release
⇒ page 46
.
❑ Brief instructions for re‐
moving and installing:
– Remove centre con‐
sole.
– Remove Bowden cable
from gearbox
⇒ page 34
.
– If necessary, disconnect
or remove parts of ex‐
Gr. 26 ; Removing and
installing parts of exhaust system .
– Remove heat shield beneath selector mechanism.
– Adjust selector lever cable after installing
⇒ page 43
.
3 - Bolt with spring
❑ 3 Nm
4 - Pin
❑ Removing
⇒ page 34
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
2. Selector mechanism
33
❑ Always renew after removing
6 - Nut
❑ 9 Nm
❑ Qty. 4
7 - Selector housing
❑ With seal
8 - Selector lever cable
❑ Bowden cable is not greased
❑ Removing and installing
⇒ page 34
❑ Checking
⇒ page 43
❑ Adjusting
⇒ page 43
9 - Securing clip
❑ Always renew after removing
10 - Hexagon flange nut
❑ 8 Nm
❑ Qty. 4
Torque setting , selector lever to selector shaft
⇒ page 30
.
2.2
Removing and installing selector lever
cable - vehicles up to 02.2009
Note
Following installation, Bowden cable must be checked for ease
of movement and be adjusted.
Removing
– Move selector lever to position “S” position.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
34
moving and installing parts of exhaust system .
– Remove -selector housing- beneath selector lever.
– Remove locking plate of cable support bracket. Always renew
locking plate.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
2. Selector mechanism
35
36
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст