Volkswagen Passat / Passat Variant (2011 year). Manual — part 82
longitudinal member cover part -1- and cut out.
Dimension -a- approx. 50 mm
Passat 2011 ➤ , Passat Variant 2011 ➤
10. Renewing rear longitudinal member - part section
325
10.3
Installing
Note
Only welding units authorised by Volkswagen AG may be used
.
10.3.1
Preparing new part
New part
♦ Rear longitudinal member
♦ Cover plate for longitudinal member
♦ Bumper mounting
♦ Floor panel (not illustrated)
♦ Connecting plate (not illustrated)
Passat 2011 ➤ , Passat Variant 2011 ➤
326
Passat 2011 ➤ , Passat Variant 2011 ➤
10. Renewing rear longitudinal member - part section
327
Welding in
Note
♦
In the area of the A, B and C-pillars, high tensile, highest tensile and hot formed steels are used. The weld
flanges in these areas are about 13mm wide.
♦
If spot welds are located at the edge of hot formed steel panels, the high temperature will cause the bond
between the panels to change, which will subsequently have an effect on crash safety.
Therefore, locate spot welds as close to the centre as possible.
• Dimension -a- of 8mm can be achieved using angled welding
tips.
– Adapt new parts with vehicle positioned on alignment bracket
set and fix in place.
– Check fit with bolt-on parts.
Passat 2011 ➤ , Passat Variant 2011 ➤
328
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст