Volkswagen 01M Transmission. Manual — part 75
Bolt
Adjusting
37-2, Adjusting
Mounting bracket/cover
Can only be removed
downward
Lock washer
Always replace
Selector lever cable
Is removed together with
selector mechanism
Item
- 15 -
Adjusting
37-2, Adjusting
Lock washer
Always replace
Mounting bracket
For selector lever cable on
transmission
Bolt, 23 Nm
Self-locking
Always replace
The threaded holes in
transmission for bolts must
always be cleaned. (e.g. with
a thread tap)
Selector lever handle, removing and installing
Removing
To ensure the handle is not damaged adhere to this
sequence:
Page 5 / 26
Selector mechanism, servicing
WWW.ALL-TRANS.BY
- Pry out selector.
- Remove bracket from handle.
- Pull button passed pressure point until it is locked in
position.
- Remove handle from selector lever.
Installing
If the handle is replaced, do not remove the assembly aid
from the new handle under any circumstances!
If the button is inadvertently pressed into the handle, hold
handle vertically and at the bottom (!). Carefully blow
button outwards again using compressed air until it can be
pulled out over the pressure point by hand.
Page 6 / 26
Selector mechanism, servicing
WWW.ALL-TRANS.BY
- Re-install assembly aid - A - (enclosed with new
handle).
- Push in clip.
- Press selector into handle again.
- Place selector lever in position "N" .
- I - Guide sleeve carefully through cover strip and cross
slide lying underneath.
- Make certain that the sleeve is carefully guided through
the cover strip when inserting. If carelessly pushing the
sleeve in, the cover strip will break.
- II - Install handle lengthwise until stop, then turn.
Installation position: Button facing driver.
- III - Press handle on selector lever up to stop until it
engages noticeably.
- Remove assembly aid - A - , operate switch and remove
sleeve upward.
- Remove protective foil on adhesive surface and affix
label - arrow - .
Page 7 / 26
Selector mechanism, servicing
WWW.ALL-TRANS.BY
Selector lever cable, checking and adjusting
Special tools, testers and auxiliary items required
Torque wrench V.A.G 1331
Socket and key T40031
Checking
- Place selector lever in position "P" .
- Remove noise insulation on bottom of transmission.
- Pull selector lever cable - 2 - from lever/selector shaft.
Page 8 / 26
Selector mechanism, servicing
WWW.ALL-TRANS.BY
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст