Volkswagen 01M Transmission. Manual — part 76
- Shift selector lever from "P" to "S" .
Selector mechanism and selector lever cable must
have freedom of movement during this, replace
selector lever cable or shift mechanism if necessary.
- Place selector lever in position "P" .
- Shift lever/switch rod at transmission in "P" position.
Catch must engage in parking lock gear, both front wheels
are locked (cannot be turned together in one direction).
It must be possible to push selector lever cable onto
lever/shift rod, if necessary adjust selector lever
cable.
- Carefully press selector lever cable onto selector shaft
lever. Do not bend lever/selector shaft when doing this,
otherwise shifting can no longer be adjusted precisely.
- Adjust selector lever cable
37-2, Adjusting
.
Adjusting
Special tools, testers and auxiliary items required
Socket and key T40031
Selector lever cable is disconnected from selector
shaft lever.
- Place selector lever in position "S" .
- Move selector shaft lever to position "D" on
transmission.
- Remove selector lever handle
37-2, Selector lever
handle, removing and installing
.
Page 9 / 26
Selector mechanism, servicing
WWW.ALL-TRANS.BY
- The procedure for disconnecting batteries must
absolutely be obeyed.
- Disconnect battery Ground (GND) strap with ignition
switched off
.
Repair Manual, Electrical Equipment, Repair Group 27,
- Remove ashtray and remove shift mechanism cover from
center console
.
Repair Manual, Body Interior, Repair Group 68,
- Remove cover from shift mechanism
37-2, Cover,
removing and installing
.
- Remove frame from shift mechanism
37-2, Frame,
removing and installing
.
- Loosen clamping bolt approx. one turn on selector lever
cable.
- Carefully push selector lever cable onto the lever/selector
shaft. When doing this, take care not to bend the
lever/selector shaft, otherwise the selector mechanism will
no longer be able to be adjusted correctly.
- Center selector lever by slightly moving selector lever
forward and backward in position "D" without leaving
position "D" .
- Tighten clamping screw to 10 Nm in this position. Socket
insert T40031 can be used for this.
Page 10 / 26
Selector mechanism, servicing
WWW.ALL-TRANS.BY
Further installation is in reverse order of removal.
- Install ashtray and selector mechanism cover in center
console
.
Repair Manual, Body Interior, Repair Group 68,
- Connect battery.
- Observe work sequence after connecting the battery
.
Repair Manual, Electrical Equipment, Repair Group 27,
Selector lever cable, removing and installing
Note:
Tying a line to the cable before removing it, will
make it possible to thread the cable back in when
installing
Topic 00-1
.
Removing
- Remove shift mechanism
37-2, Selector mechanism,
removing and installing
.
- Push boot - arrow - forward and out from shift unit.
To remove selector lever cable, the transfer case only
needs to be lowered.
- Lower transfer case
Page 11 / 26
Selector mechanism, servicing
WWW.ALL-TRANS.BY
.
Repair Manual, Rear Final Drive, Repair Group 34,
Transfer case, removing and installing
- Remove locking washer - 1 - .
- Pull selector lever cable - 2 - from lever/selector shaft.
Installing
- Insert selector lever cable into shift unit - 1 - .
- Seat sleeve - 2 - so that it makes full contact against
shift unit.
- Install the transfer case
.
Repair Manual, Rear Final Drive, Repair Group 34,
Page 12 / 26
Selector mechanism, servicing
WWW.ALL-TRANS.BY
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст