Volkswagen 01M Transmission. Manual — part 81
Removing
- For all engine variations, it is advisable to remove the
"lower connecting bolts" of the engine/transmission, even
before the removal of the gear set.
When possible, the torque converter fasteners should also
be mounted early on.
- Remove engine with transmission
.
Repair Manual, Engine Mechanical, Repair Group 10,
Vehicles with V6 and V8 gasoline engines
- Remove starter motor
.
Repair Manual, Electrical Equipment , Repair Group 27,
- Remove torque converter from drive plate.
Page 3 / 12
Transmission, removing and installing
WWW.ALL-TRANS.BY
Vehicles with V10 TDI
- Remove starter cable so far until bolt - arrow - can be
removed
.
Repair Manual, Electrical Equipment, Repair Group 27,
On these models, the torque converter fasteners and the
lower engine/transmission bolts should be installed with the
gear set mounted.
Make sure that at least two plates VAS 6131/1 on the
lifting table are placed under oil pan as support for
automatic transmission.
- Remove driveshaft between transfer case and front final
drive.
- To counter-hold the driveshaft, the counter-hold tool
T10172 can be used.
Page 4 / 12
Transmission, removing and installing
WWW.ALL-TRANS.BY
- The counter-holder 3435 with two bolts up to M10 is also
recommended.
or: Retainer T10172
- Support transfer case with crane.
- Separate transfer case and set aside
.
Repair Manual, Rear Final Drive, Repair Group 34,
Before engine and transmission are separated from each
Page 5 / 12
Transmission, removing and installing
WWW.ALL-TRANS.BY
other, secure engine from tipping over.
- If a second crane is not available, separate the engine
and transmission and then support the engine with
available materials.
- Support transmission with crane
37-3, Transmission,
transporting
.
- Loosen ATF lines
37-5, ATF lines and ATF cooler
.
- Remove all connecting bolts for engine/transmission.
- Carefully press transmission off engine.
- Make sure that the converter is also pressed from drive
plate with transmission.
Installing
Installation is in reverse order of removal.
- Check adjustment of selector lever cable and adjust if
necessary
37-2, Selector lever cable, checking and
adjusting
.
After installation, check the ATF level, if necessary top off
37-4, ATF level, checking and topping off
and check the
vehicle alignment
.
Repair Manual, Suspension, Wheels, Steering, Repair
Group 44,
Tightening torques, vehicles with V6 gasoline engine
Topic 37-3
.
Tightening torques, vehicles with V8 FSI gasoline engine
(FSI)
Topic 37-3
.
Tightening torques, vehicles with V8 gasoline engine (TSI)
Topic 37-3
.
Tightening torques, vehicles with V10 TDI
Topic 37-3
.
Torque specifications
Vehicles with V6 gasoline engine
Page 6 / 12
Transmission, removing and installing
WWW.ALL-TRANS.BY
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст