Volkswagen Jetta / Jetta Hybrid. Manual — part 54
– Disconnect connector -2-.
– Remove the three screws -3-.
– Remove window regulator motor together with control unit
-1- from mounting brackets.
2.4.2
Installing
WARNING
If a new window regulator motor is installed (door control unit),
the additional functions and the excess force limitation feature
have to be coded!
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
2. Front door window
213
the splines between window regulator motor and cable drum
engage more easily.
– Screw in the three screws -3-.
Specified torque for bolts -3-: 4 Nm.
– Connect connector -2-.
WARNING
Before installing door trim, check that the holes in the door
panel are sealed with respective stickers
⇒ page 114
.
– A new window regulator motor must be coded using the vehi‐
cle diagnosis, testing and information system -VAS 5051B- .
– The work procedure and notes on the automatic window rais‐
ing and lowering system as well as on the excess-force limi‐
tation feature can be found in ⇒ Maintenance ; Booklet .
Further installation is performed in the reverse order of removal.
2.5
Removing and installing window regula‐
tor
Note
Removal and installation are described only for the right window
regulator. The removal and installation of the left window regulator
is similar.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
214
Carry out following work:
– Remove door window
⇒ page 206
.
– Removing window regulator motor
⇒ page 212
– Release locking hook of cable drum -arrows b- and push into
door.
– Only undo lower nuts -3- and push threaded bolts of window
regulator into door.
– Loosen upper nuts -3- (do not remove completely), move to‐
gether with window regulator in -direction of arrow a- and push
into door.
– Remove window regulator -2- together with cable drum out of
opening in door -arrows c-, -d- and -e-.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
2. Front door window
215
Carry out following work:
– Insert window regulator -2- together with cable drum through
opening in door -arrows a-, -b- and -c-.
– Insert upper threaded bolts with nuts -3- through the door skin
and move in -direction of arrow d-.
– Insert lower threaded bolts of window regulator through the
door skin.
– Screw on lower nuts -3- and then tighten all nuts -3-.
Specified torque for nuts -3-: 8 Nm
– Insert guides of cable drum through door skin until locking
hooks engage -arrows e-.
– Install window regulator motor
⇒ page 212
– Install door window
⇒ page 206
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
216
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст