Volkswagen Jetta / Jetta Hybrid. Manual — part 55
nel
Note
♦
Removal and installation is described only for the right window
channel. The removal and installation of the left window chan‐
nel is similar.
♦
Do not bend the window slot seals when lifting off!
2.6.1
Removing
Carry out following work:
– Remove door window
⇒ page 206
.
– Remove window slot inner seal
⇒ page 105
.
– Remove window slot outer seal
⇒ page 108
.
– Pull out retaining clip -3- -arrow c-.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
2. Front door window
217
– Pull window channel -1- -arrows a- off flange -2- uniformly all
around it.
– Pull window channel -1- out of mountings -arrows b-.
2.6.2
Installing
Carry out following work:
– Openings -4- beneath window channel are masked off with
textile adhesive tape.
Adhesive tape dimensions: height = approx. 10 mm, width = ap‐
prox. 40 mm.
– Spray window channel with soapy water to facilitate installa‐
tion.
– Push window channel -1- into mountings -arrows a-.
– Push window channel -1- evenly all around onto the door
flange -2-.
– Fold sealing lip of window channel onto door flange from the
inside.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
218
– Push in retaining clip -3- -arrow c-.
Note
♦
Retaining clip inclination must point to inner side of vehicle (vehicle interior).
♦
If retaining clip inclination points to outer side of vehicle -scored through in red-, retaining clip must be turned
around.
Further installation is performed in the reverse order of removal.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
2. Front door window
219
3.1
Tools
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1783-
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
220
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст