Volkswagen Jetta / Jetta Hybrid. Manual — part 69
– With the help of a second mechanic, place rear spoiler -2- on
rear lid and align rear spoiler.
– Press left and right outer sides down onto rear lid -arrows- and
simultaneously pull off remaining protective foil of double-si‐
ded adhesive tape -3- on rear spoiler -2-.
– Press rear spoiler -2- on evenly along the entire length.
• Observe minimum curing period
⇒ page 273
.
Minimum curing period
WARNING
♦ The vehicle is safe to use and can be operated only after
the minimum curing period is completed.
Adhesive sealant
Minimum cur‐
ing period in
hours
Rear spoiler onto rear
lid
1K glass adhesive ⇒
Electronic parts cata‐
logue “ETKA”
3
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
4. Rear spoiler
273
5.1
Water deflector
5.1.1
Tools
Special tools and workshop equipment required
♦ Setting gauge -3371-
♦ Hot air blower -V.A.G 1416-
♦ Adhesive strip remover -VAS 6349-
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
274
Note
The right side is shown. The left side is similar.
1 - Water deflector
2 - Retaining strip
Caution
Only remove and install
with windscreen re‐
moved as otherwise
windscreen will become
damaged.
3 - Pop rivet
❑ Qty. 5.
❑ Drill out pop rivets to re‐
move retaining strip.
❑ To install retaining strip,
install pop rivets using
rivet pliers (e.g. -VAS
5072- )
4 - Adhesive tape
❑ Part of water channel
❑ Only remove protective
film just before bonding
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
5. Mouldings and trims
275
Carry out following work:
– Lever out water channel -1- from retaining strip, starting from
top -arrow-.
– Gently heat up adhesive tape of retaining strip on front wing
-2- using hot air gun -V.A.G 1416- and carefully pull off.
5.1.4
Installing
Fitting notes
♦ If a water channel is removed and installed, only use adhesive
remover -D 002 000 10- to remove any adhesive residue.
♦ Remove any existing adhesive residue of adhesive tape using
adhesive strip remover -VAS 6349- .
♦ Ensure that surfaces to be bonded are free of dust and grease.
♦ Bond water channel immediately after cleaning.
♦ Remove protective backing immediately before installation.
♦ Working temperature is approx. 21 °C.
Carry out following work:
Follow installation instructions
⇒ page 276
.
– Check gap -a- over complete length of retaining strip -1- using
gauge -3371- .
• Distance -a- between -arrows-: 0.9…1.1 mm
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
276
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст