Volkswagen Jetta / Jetta Hybrid. Manual — part 70
plastic wedge -2- and hammer -3-.
– Check gap -a- again over complete length of retaining strip
-1-, after making changes, using gauge -3371- .
• Distance -a- between -arrows-: 0.9…1.1 mm
– Press water channel -1- into retaining strip -5-, starting from
top -arrow-.
Note
The water channel -1- should not protrude above the edge of the
roof (wind noises).
– When doing this, guide water channel lip -3- behind edge of
windscreen -4-.
6 - Pop rivet
7 - Body flange
– Bond adhesive tape of retaining strip on front wing -2- as fol‐
lows.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
5. Mouldings and trims
277
– Pull off protective backing -2- in direction of -arrow b- and
press water channel onto front wing firmly.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
278
Note
Only the left side is shown. The right side is similar.
1 - Side member cover
❑ Removing
– Unscrew bolts -2- and
remove sill panel cover.
❑ Installing
• Check spreader nuts -3- for
damage and renew if nec‐
essary.
– Locate sill cover, screw
bolts -2- in and tighten.
2 - Bolt
❑ Qty. 3.
❑ Specified torque: 2 Nm
3 - Expanding nut
❑ Qty. 3.
❑ Renew if damaged
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
5. Mouldings and trims
279
1 - B-pillar trim
2 - Securing pins
❑ Part of trim.
3 - Clip
4 - Grommet
❑ Qty. 4.
5 - Spreader rivet
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
280
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст