Volkswagen Jetta / Jetta Hybrid. Manual — part 18
Note
♦
Number plate carrier is not installed in all models or in all markets.
♦
Number plate carriers of different sizes are fitted in various markets.
1 - Pop rivet nut
❑ Qty. 2.
2 - Registration plate carrier
❑ Assignment ⇒ Parts
catalogue “ETKA”
3 - Bolt
❑ Qty. 2.
❑ Specified torque: 4 Nm
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
2. Rear lid
69
3.1
Tools
Special tools and workshop equipment required
♦ Removal wedge -3409-
♦ Socket -T10072-
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
70
1 - Connector
❑ For tank filler flap lock‐
ing motor -V155-
2 - Tank filler flap locking motor
-V155-
❑ Removing and installing
⇒ page 73
3 - Tank flap unit
❑ Removing and installing
⇒ page 71
4 - Bolt
❑ Specified torque: 1.5
Nm
5 - Water drain hose
❑ Routed between wheel
housing and wheel
housing liner
3.3
Removing and installing tank flap unit
3.3.1
Removing
Carry out following work:
– Screw off tank cover.
– Peel rubber grommet of tank flap unit -1- off tank filler neck
-2-.
– Remove bolt -3-.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
3. Tank flap unit
71
– Release remaining locking mechanisms of tank flap unit using
removal wedge -3409- in specified sequence -arrows 2 … 4-.
– Swing out tank flap unit with water drainage hose from side
panel.
3.3.2
Installing
Carry out following work:
– Insert water drainage hose -4- through opening in tank flap unit
-3- and pull through water drainage hose as far as it will go.
– Push water drainage hose-4- between wheel housing and
wheel housing liner and into the side panel.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
72
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст