Volkswagen Jetta / Jetta Hybrid. Manual — part 61
Carry out following work:
Note
Check spreader nuts -3- for damage and renew if necessary.
WARNING
♦ Check gas-tight spreader nuts -4- for damage and renew
if necessary.
♦ The spreader nut seals the interior against exhaust gases
and must always be renewed in the event of damage.
– Insert wheel housing liner -1- into wing.
– Screw in bolts -2- and tighten them.
Specified torque for bolts -2-: 2 Nm.
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
1. Wheel housing liner
241
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
242
2.1
Tools
Special tools and workshop equipment required
♦ Wedges -T10383-
♦ Torque wrench -V.A.G 1783-
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
2. Exterior mirror
243
Note
The right side is shown. The left side is similar.
1 - Mirror housing
❑ Material: ABS.
❑ Removing and installing
⇒ page 248
2 - Mirror mounting
❑ Removing and installing
⇒ page 252
3 - Trim
❑ Removing and installing
⇒ page 247
4 - Mirror glass
❑ Removing and installing
⇒ page 245
5 - Adjuster unit
❑ Cannot be separated
from mirror mounting
-2-
6 - Insulation
7 - Bolt
❑ Specified torque: 12 Nm
Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
244
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст