Volkswagen Jetta Hybrid (2013 year). Manual — part 14
– Disconnect connector from selector lever cover.
– Push sleeve upwards in -direction of arrow- to release knob.
– Pull selector lever handle together with cover upwards, without
pressing the push-button.
Installing
Install in reverse order of removal, observing the following:
• Selector lever is in position “D”.
Caution
Risk of damage to selector mechanism.
♦ When installing, the push-button on the selector lever
handle must not be pressed in. If the push-button was
pressed by mistake, the installation position must be re‐
stored
⇒ page 49
.
♦ If the selector lever handle is installed with push-button
pressed, the selector lever handle and the tie rod -3- of the
selector mechanism will be destroyed.
Note
♦
New handles are supplied with installation guard. Do not re‐
move guard until just before installing. To remove, pull out in
direction of -arrow-.
♦
If an installation guard is installed, the installation position can
also be restored
⇒ page 49
.
– Press selector lever handle -1- onto selector lever to stop,
without pressing the push-button while doing so.
– Lock knob again after installing. Press sleeve under handle
back down towards selector mechanism.
– Push push-button after installing.
Note
If not installed correctly, push button remains inserted in handle
after being pressed. If this happens, remove handle again and
move push button to installation position again
⇒ page 49
. The
handle can then be installed again.
– Pull gaiter back down and engage cover.
– Check selector mechanism
⇒ page 59
.
1.4
Moving push-button to installation posi‐
tion in the handle
If the push-button was pressed by mistake, the installation posi‐
tion can be restored.
Jetta Hybrid 2013 ➤
1. Selector mechanism
49
described here.
Place handle »with« installation guard in installation position:
When using the installation guard, make sure that it has an eyelet
-arrow- at the front. Other types of installation guard are not suit‐
able.
– Holding down push button, completely push in installation
guard with eyelet -arrow- until installation guard engages, then
release push button. When the installation guard is pulled out,
the push button engages in the installation position.
Place handle »without« installation guard in installation position:
– Carefully unclip trim of handle -A- upwards.
Jetta Hybrid 2013 ➤
50
back into installation position.
-I- Push button in pressed position
-II- Push button in installation position
Note
♦
Only press the lever into the groove and no further.
♦
Do not clip the trim of the handle onto the selector mechanism
until the handle has been fitted. This makes it possible to check
whether the small lever engages in the tie rod when the push
button is pressed.
1.5
Removing and installing selector mech‐
anism
⇒ “1.5.1 Removing and installing selector mechanism with selec‐
tor housing”, page 51
⇒ “1.5.2 Removing and installing selector mechanism without se‐
lector housing”, page 55
Special tools and workshop equipment required
♦ Removal lever -80 - 200-
Note
♦
Selector mechanism and selector lever cable are not allowed
to be separated from one another. Both are removed together.
♦
Following installation, selector lever cable must be checked
for ease of movement and be adjusted.
1.5.1
Removing and installing selector mech‐
anism with selector housing
The selector mechanism with selector lever cable can be re‐
moved and installed separately without removing and installing
the selector housing
⇒ page 55
.
Jetta Hybrid 2013 ➤
1. Selector mechanism
51
⇒ page 48
, pulling off connector
-2- from cover in process.
gr. 68 ; Centre console; Removing and installing centre con‐
sole .
– Separate electrical connector for vehicle wiring harness -1-
from selector mechanism.
Vehicles with secondary air system
– Unclip cover for air damper -1- upwards from mountings
-arrows- and remove it.
– Disconnect air hoses -1- and -2- from air damper -3-. To do
this, press retaining ring -arrow- together on both sides and
pull hoses off.
Jetta Hybrid 2013 ➤
52
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст