Volkswagen Jetta Hybrid (2013 year). Manual — part 30
.
– Unscrew bolts -2- and pull parking lock -1- off dowel sleeves
-arrows-.
If the parking lock cannot be pulled off by hand:
– Fit multipurpose tool -VW 771- with extractor hook -VW
771/37- behind parking lock and remove parking lock by al‐
ternately pulling it out.
– Renew bolts -2-.
Installing
– Fit parking lock -1- onto dowel sleeves -arrows-.
– Screw in new bolts -2-.
– Install parking lock cover -1-
⇒ page 110
.
Specified torques
Component
Specified torque
Parking lock to gearbox housing
• Renew bolts after each remov‐
al.
20 Nm + 90° further
Jetta Hybrid 2013 ➤
1. Parking lock
113
Oil seals
⇒ “1.1 Fitting location overview - seals”, page 114
⇒ “1.2 Renewing left oil seal”, page 114
⇒ “1.3 Renewing right oil seal”, page 118
1.1
Fitting location overview - seals
1 - Renewing input shaft seal
❑ Renewing
⇒ page 23
2 - Seal for inner input shaft
❑ Renewing
⇒ page 25
3 - Right intermediate shaft
4 - Bolt
❑ 30 Nm
5 - Retaining ring
❑ Renew.
6 - O-ring
❑ Renew.
7 - Seal, right
❑ For right intermediate
shaft.
❑ Renewing
⇒ page 118
8 - Seal, left
❑ For left flange shaft
❑ Renewing
⇒ page 114
9 - Left flange shaft
1.2
Renewing left oil seal
Special tools and workshop equipment required
Jetta Hybrid 2013 ➤
114
♦ Socket -T10107 A-
♦ Used oil collection and extraction unit -V.A.G 1782-
♦ Sealing grease -G 052 128 A1-
Jetta Hybrid 2013 ➤
1. Oil seals
115
♦
Observe
⇒ “4 Repair instructions”, page 10
.
♦
Do not loosen the centre bolt of the drive shaft.
– Remove front left wheel.
– Remove noise insulation beneath engine/gearbox ⇒ General
body repairs, exterior; Rep. gr. 66 ; Noise insulation .
– Remove front left wheel housing liner ⇒ General body repairs,
exterior; Rep. gr. 66 ; Wheel housing liner; Removing and
installing wheel housing liner .
– If present, undo bolts securing front left vehicle level sender -
G78- and remove sender from suspension link.
– Turn steering wheel to left lock and remove left drive shaft from
flange shaft ⇒ Running gear, axles, steering; Rep. gr. 40 ;
Drive shaft; Removing and installing drive shaft .
– Only unscrew left suspension link from swivel joint.
– Detach left swivel joint from wishbone.
– Unscrew nut -1- from coupling rod -3- ⇒ Running gear, axles,
roll bar .
– Pull off coupling rod and turn anti-roll bar -2- upwards slightly.
– Swing left drive shaft into wheel housing.
– Raise drive shaft as high as possible and secure. Take care
not to damage paint on drive shaft in the process.
– Position used oil collection and extraction unit -V.A.G 1782-
under gearbox.
Jetta Hybrid 2013 ➤
116
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст