Kia Carnival (2009+). Instruction — part 492

4. Remove the left and right side anti-pinch strip sensor (B) after removing the screws (5EA).

5. Installation is the reverse of removal. Part (C) has to be assembled using the cloth.

Body Electrical System

Power Tail Gate System - PTG Power Latch

Body Electrical System

2009 > G 2.7 DOHC >

INPECTION

1. Check the power tail gate control module input/output value by using the diagnostic tool. If the operation of tailgate

control module is abnormal, replace power latch.

2. To check the power latch operation, select a vehicle type and "POWER SLIDING/TAILGATE" menu.

3. Select "POWER TAILGATE".

4. Select the sensor output. And then check the cinch feedback and unlatch feedback output while operating power

tailgate in power mode.

※ Above voltage and numerical value may be different from the real value.

5. Change the anti pinch strip sensor, if there is no change during operation.

REPLACEMENT

1. Disconnect the negative (-) battery terminal.

2. Remove the tail gate trim (Refer to the Body group - tail gate).

3. Remove the tail gate handle rod, actuator rod and key rod.

4. Remove the unlatch actuator assembly (A) after removing the connector and nuts (3EA).

5. Remove the tail gate handle rod (A) and connector (B) from the cinching latch assembly (C).

6. Remove the latch mounting screws (3EA) and cinching latch assembly (A) from the tail gate.

7. Installation is the reverse of removal.

- Check the power tail gate for normal operation.
- Check the normal operating whenever a power tailgate component is removed or replaced. If the chime

sound is heard, check the DTC, wiring harness and cable connections.