Kia Carnival (2009+). Instruction — part 491

Body Electrical System

Power Tail Gate System - PTG Module

Body Electrical System

2009 > G 2.7 DOHC >

REPLACEMENT

1. Disconnect the negative (-) battery terminal.

2. Remove the third, fourth seat (Refer to the Body group - seat)

3. Remove the D pillar and luggage side trim (Refer to the Body group - Interior trim).

4. Use a small screw driver to loosen clip (A). But do not remove power tailgate push rod (B).

5. Remove the power tail gate module mounting bolts (2EA) and connectors (2EA). And then remove the power tail

gate module (A).

TORQUE : 25-35N.m(2.5-3.5Kg.m)

6. Installation is the reverse of removal

- Connect the connectors tightly.
- Check the power tail gate for normal operation correctly.

- A lost drive unit mounting bolt in the vehicle may make a noise.
- Don't operate the power tail gate when a push rod is removed.
- A learn cycle must be performed whenever the power is removed.
- Check the normal operating whenever a power tailgate component is removed or replaced. If the chime

sound is heard, check the DTC, wiring harness and cable connections.

Body Electrical System

Power Tail Gate System - Anti-Pinch Strip

Body Electrical System

2009 > G 2.7 DOHC >

INSPECTION

1. Check the power tail gate control module input/output value by using the diagnostic tool. If the operation of tailgate

control module is abnormal, replace anti pinch strip control module.

2. When checking the anti pinch strip operation, select a vehicle type and "POWER SLIDING/TAILGATE" menu.

3. Select "POWER TAILGATE".

4. Select the sensor output. And then check the anti pinch strip sensor output while operating power tailgate in power

mode.

※ Above voltage and numerical value may be different from the real value.

5. Change the anti pinch strip sensor, if there is no change from OFF to ON during operation.

REPLACEMENT

1. Disconnect the negative (-) battery terminal.

2. Remove the tail gate trim (Refer to the Body group - tail gate).

3. Remove the anti-pinch strip sensor connector (A).