Isuzu Amigo / Axiom / Trooper / Rodeo / VehiCross. Service manual — part 1553
7A–52
AUTOMATIC TRANSMISSION (4L30–E)
13. Install harness heat protector (V6).
Torque: 6 N
•
m (52 lb in)
815RW002
14. Connect transmission harness connector and clip.
Connector : Adapter case, mode switch, main case,
magnetic sensor, transfer switch (4
×
4), 2–4 actuator
(4
×
4) and car speed sensor.
15. Connect fuel pipe bracket to transmission side.
NOTE: See “NOTE” of removal steps.
(V6, 4
×
4)
141R100004
(V6, 4
×
4)
240RW014
(V6, 4
×
2)
141RW006
7A–53
AUTOMATIC TRANSMISSION (4L30–E)
(HEC)
253R100002
(HEC)
141R100003
16. Install fuel pipe heat protector and clip.
17. Connector fuel pipe bracket to third crossmember.
141RW004
18. Install center exhaust pipe (V6, 4
×
4).
Torque: 43 N
•
m (32 lb ft)
150RW008
7A–54
AUTOMATIC TRANSMISSION (4L30–E)
19. Install front propeller shaft (4
×
4) and rear propeller
shaft.
Torque: 63 N
•
m (46 lb ft)
20. Install transfer protector (4
×
4) and fairing plate (V6).
150RW006
7A–55
AUTOMATIC TRANSMISSION (4L30–E)
Solenoid (Main Case Valve Body)
Removal
1. Raise the vehicle and support it on jack stands.
2. Disconnect battery ground cable.
3. Drain fluid.
4. Remove sixteen 10 mm screws, main case oil pan,
magnet, and gasket.
5. Remove three 13 mm screws, oil filter.
6. Disconnect wiring harness from band control
solenoid and shift solenoids. Pull only on connectors,
not on wiring harness.
7. Remove spring pin for shift solenoid A, shift solenoid
B, and band control solenoid respectively, using
suitable pliers taking care not to damage solenoids.
210RW010
244RW003
8. Remove shift solenoid A, shift solenoid B, band
control solenoid, and gaskets from main case valve
body. Do not pull on wiring harness. Remove
solenoids by grasping the metal tip.
Installation
1. Install shift solenoid A, shift solenoid B, band control
solenoid with new gaskets to main case valve body
respectively.
2. Carefully install spring pin with hammer to avoid
damage to valve body, etc.
243RW004
3. Connect wiring harness to solenoids.
4. Install oil filter with a new gasket and the three 13 mm
screws, tighten to the specified torque.
Torque: 20 N
•
m (15 lb ft)
5. Install magnet, main case oil pan with new gasket,
and sixteen 10 mm screws. Tighten the screws to the
specified torque.
Torque: 11 N
•
m (96 lb in)
6. Fill transmission through the overfill screw hole of oil
pan, using ATF DEXRON
–III. Refer to Changing
Transmission Fluid in this section.
7. Connect battery ground cable.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст