Nissan X-Trail 32. Instruction — part 2215
C1704-00, C1705-00, C1706-00, C1707-00 LOW TIRE PRESSURE
WT-33
< DTC/CIRCUIT DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
DTC/CIRCUIT DIAGNOSIS
C1704-00, C1705-00, C1706-00, C1707-00 LOW TIRE PRESSURE
DTC Description
INFOID:0000000010715074
DTC DETECTION LOGIC
NOTE:
The actual malfunction part may differ from the malfunction part which DTC shows if ID registration is not per-
formed after performing tire rotation or tire/road wheel replacement.
POSSIBLE CAUSE
• Low tire pressure (natural air leak)
• Air leak because of wheel change
DTC CONFIRMATION PROCEDURE
1.
PERFORM DTC CONFIRMATION
With CONSULT
1.
Turn the ignition switch ON.
CAUTION:
Never start the engine.
2.
Check the tire pressure for all wheels and adjust to the specified value. Refer to
.
3.
Perform TPMS reset operation. Refer to
4.
Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
5.
Perform self-diagnosis for “AIR PRESSURE MONITOR”.
Is DTC “C1704-00”, “C1705-00”, “C1706-00”, or “C1707-00” detected?
YES
>> Proceed to
.
NO-1
>> To check malfunction symptom before repair: Refer to
GI-44, "Intermittent Incident"
NO-2
>> Confirmation after repair: INSPECTION END
Diagnosis Procedure
INFOID:0000000010715075
1.
TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to
.
Is tire pressure sensor ID registration completed?
YES
>> GO TO 2.
NO
>> Replace applicable tire pressure sensor. Refer to
WT-62, "Removal and Installation"
2.
CHECK TIRE PRESSURE
1.
Turn the ignition switch ON.
CAUTION:
Never start the engine.
2.
Check the tire pressure of all wheels. Refer to
.
CAUTION:
DTC No.
CONSULT screen item
(Trouble diagnosis content)
DTC Detection Condition
C1704-00
LOW PRESSURE FL
(Low tire pressure front left)
Front left tire pressure drops.
C1705-00
LOW PRESSURE FR
(Low tire pressure front right)
Front right tire pressure drops.
C1706-00
LOW PRESSURE RR
(Low tire pressure rear right)
Rear right tire pressure drops.
C1707-00
LOW PRESSURE RL
(Low tire pressure rear left)
Rear left tire pressure drops.
WT-34
< DTC/CIRCUIT DIAGNOSIS >
C1704-00, C1705-00, C1706-00, C1707-00 LOW TIRE PRESSURE
If the checked value is close to the standard, reduce the tire pressure, and then with the ignition
switch ON, adjust the tire pressure again so that it is within the standard.
3.
Perform TPMS reset operation. Refer to
4.
Drive for 2 minutes or more at a speed of between 25 km/h (16 MPH) and 100 km/h (62 MPH).
5.
Recheck the tire pressure of all wheels. Refer to
Is the inspection result normal?
YES
>> Perform “DTC CONFIRMATION PROCEDURE” (self-diagnosis) again. Refer to
.
NO
>> GO TO 3
3.
CHECK TIRE PRESSURE SIGNAL
With CONSULT
1.
Adjust tire pressure for all wheels to the specified value. Refer to
2.
Select “DATA MONITOR” in “AIR PRESSURE MONITOR”.
3.
Check that the tire pressures match the standard value.
Is the inspection result normal?
YES
>> Check air leak using soapsuds etc. and repair or replace error-detected parts. After erasing DTC
record, INSPECTION END.
NO
>> Repair or replace error-detected parts.
Monitor item
Displayed value
AIR PRESS FL
Approximately equal to the indication on tire gauge value for front left tire
AIR PRESS FR
Approximately equal to the indication on tire gauge value for front right tire
AIR PRESS RR
Approximately equal to the indication on tire gauge value for rear right tire
AIR PRESS RL
Approximately equal to the indication on tire gauge value for rear left tire
C1708-00, C1709-00, C1710-00, C1711-00 TIRE PRESSURE SENSOR
WT-35
< DTC/CIRCUIT DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
C1708-00, C1709-00, C1710-00, C1711-00 TIRE PRESSURE SENSOR
DTC Description
INFOID:0000000010715076
DTC DETECTION LOGIC
NOTE:
The actual malfunction part may differ from the malfunction part which DTC shows if ID registration is not per-
formed after performing tire rotation or tire/road wheel replacement.
POSSIBLE CAUSE
• BCM harness or connector
• BCM
• Tire pressure sensor ID registration incomplete
• Tire pressure sensor is not attached.
• Tire pressure sensor
• Tire pressure sensor battery voltage
• Driving in area where radio wave cannot be transmitted/received.
DTC CONFIRMATION PROCEDURE
1.
TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to
.
Can the tire pressure sensor ID registration be completed?
YES
>> GO TO 2.
NO
>> Replace applicable tire pressure sensor. Refer to
WT-62, "Removal and Installation"
2.
PERFORM DTC CONFIRMATION
With CONSULT
1.
Drive the vehicle at 40 km/h (25 MPH) or more.
NOTE:
Avoid driving in area where radio wave cannot be transmitted/received.
2.
Stop the vehicle.
3.
Perform self-diagnosis for “AIR PRESSURE MONITOR”.
Is DTC “C1708-00”, “C1709-00”, “C1710-00” or “C1711-00” detected?
YES
>> Proceed to
.
NO-1
>> To check malfunction symptom before repair: Refer to
GI-44, "Intermittent Incident"
NO-2
>> Confirmation after repair: INSPECTION END
Diagnosis Procedure
INFOID:0000000010715077
1.
CHECK TIRE PRESSURE SIGNAL
With CONSULT
1.
Select “DATA MONITOR” in “AIR PRESSURE MONITOR”.
2.
Check the values that are displayed for “AIR PRESS FL”, “AIR PRESS FR”, “AIR PRESS RR”, and “AIR
PRESS RL”.
NOTE:
BCM holds last tire pressure values during 17 minutes after ignition switch turns OFF.
DTC No.
CONSULT screen item
(Trouble diagnosis content)
DTC Detection Condition
C1708-00
[NO - DATA] - FL
(No data front left)
Tire pressure data signal from the front left wheel tire pressure sensor cannot be
detected.
C1709-00
[NO - DATA] - FR
(No data front right)
Tire pressure data signal from the front right wheel tire pressure sensor cannot
be detected.
C1710-00
[NO - DATA] - RR
(No data rear right)
Tire pressure data signal from the rear right wheel tire pressure sensor cannot be
detected.
C1711-00
[NO - DATA] - RL
(No data rear left)
Tire pressure data signal from the rear left wheel tire pressure sensor cannot be
detected.
WT-36
< DTC/CIRCUIT DIAGNOSIS >
C1708-00, C1709-00, C1710-00, C1711-00 TIRE PRESSURE SENSOR
Are all tire pressures displayed 0 kPa (psi)?
YES
>> GO TO 2.
NO
>> Replace applicable tire pressure sensor. Refer to
WT-62, "Removal and Installation"
2.
TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to
.
Can the tire pressure sensor ID registration be completed?
YES
>> GO TO 3.
NO
>> Replace applicable tire pressure sensor. Refer to
WT-62, "Removal and Installation"
3.
CHECK BCM POWER SUPPLY CIRCUIT
Check BCM power supply circuit. Refer to
BCS-114, "Diagnosis Procedure"
.
Is the inspection result normal?
YES
BCS-121, "Removal and Installation"
NO
>> Repair or replace harness or connectors.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст