Nissan Teana J32. Instruction — part 623
FRONT SUSPENSION MEMBER
FSU-17
< REMOVAL AND INSTALLATION >
C
D
F
G
H
I
J
K
L
M
A
B
FSU
N
O
P
NOTE:
Remove the steering knuckle and wheel bearing assembly, steering gear assembly and hydraulic line,
stabilizer bar, transverse link and engine mounting insulator as a unit from the vehicle.
18. Remove the following parts.
• Steering knuckle and wheel hub and bearing assembly: refer to
.
• Steering gear assembly and hydraulic line: refer to
.
• Stabilizer bar: refer to
• Transverse link: refer to
• Engine mounting insulator: refer to
INSTALLATION
Note the following, and install in the reverse order of removal.
• Perform final tightening of installation position between front suspension member and transverse links (rub-
ber bushing) under unladen condition with tires on level ground.
Inspection
INFOID:0000000003811128
INSPECTION AFTER REMOVAL
Check the front suspension member for significant deformation, cracks, or damages. Replace if necessary.
INSPECTION AFTER INSTALLATION
1.
Check wheel sensor harness for proper connection. Refer to
(without VDC),
BRC-151, "FRONT WHEEL SENSOR : Exploded View"
(with VDC).
2.
Check wheel alignment. Refer to
FSU-7, "Wheel Alignment Inspection"
.
3.
Adjust the neutral position of the steering angle sensor. Refer to
BRC-66, "ADJUSTMENT OF STEERING
FSU-18
< SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Wheel Alignment
INFOID:0000000003811129
Measure value under unladen* conditions.
*: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions.
Ball Joint
INFOID:0000000003811130
Wheel Height
INFOID:0000000003811131
Item
Standard
Camber
Degree minute (Decimal degree)
Minimum
–1
°
10
′
(–1.16
°
)
Nominal
–0
°
25
′
(–0.42
°
)
Maximum
0
°
20
′
(0.33
°
)
Left and right difference
0
°
45
′
(0.75
°
) or less
Caster
Degree minute (Decimal degree)
Minimum
4
°
10
′
(4.17
°
)
Nominal
4
°
55
′
(4.92
°
)
Maximum
5
°
40
′
(5.66
°
)
Left and right difference
0
°
45
′
(0.75
°
) or less
Kingpin inclination
Degree minute (Decimal degree)
Minimum
11
°
55
′
(11.92
°
)
Nominal
12
°
40
′
(12.67
°
)
Maximum
13
°
25
′
(13.41
°
)
Total toe-
in
Distance
Minimum
In 0.5 mm (0.020 in)
Nominal
In 1.5 mm (0.059 in)
Maximum
In 2.5 mm (0.098 in)
Angle (left wheel or right wheel)
Degree minute (Decimal degree)
Minimum
In 0
°
02
′
(0.04
°
)
Nominal
In 0
°
04
′
(0.07
°
)
Maximum
In 0
°
06
′
(0.10
°
)
Item
Standard
Swing torque
Transverse link
0.5 – 4.9 N·m (0.06 – 0.49 kg-m, 5 – 43 in-lb)
Measurement on spring balance
Transverse link
11.1 – 108.9 N (1.2 – 11.1 kg, 3 – 24 lb)
Rotating torque
Transverse link
0.5 – 3.4 N·m (0.06 – 0.34 kg-m, 5 – 30 in-lb)
Axial end play
0.1 mm (0.004 in)
Tire size
205/65R16
215/55R17
Engine
VQ25DE
VQ35DE
Grade
250XE
250XL-V6
250XV-V6
350XV-V6
Front (Hf)
712 mm (28.03 in)
711 mm (27.99 in)
710 mm (27.95 in)
SERVICE DATA AND SPECIFICATIONS (SDS)
FSU-19
< SERVICE DATA AND SPECIFICATIONS (SDS)
C
D
F
G
H
I
J
K
L
M
A
B
FSU
N
O
P
Measure value under unladen* conditions.
*: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions.
Rear (Hr)
703 mm (27.68 in)
702 mm (27.64 in)
701 mm (27.60 in)
Tire size
205/65R16
215/55R17
Engine
VQ25DE
VQ35DE
Grade
250XE
250XL-V6
250XV-V6
350XV-V6
SFA818A
MODEL J32 SERIES
© 2008 NISSAN INTERNATIONAL SA
All rights reserved. No part of this Electronic Service Instruction may be reproduced or stored in a retrieval system, or transmitted in any form,
or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of Nissan International
SA, Switzerland.
A GENERAL INFORMATION
B ENGINE
D TRANSMISSION
& DRIVELINE
E SUSPENSION
F BRAKES
G STEERING
H RESTRAINTS
I VENTILATION, HEATER
& AIR CONDITIONER
J BODY INTERIOR
K BODY EXTERIOR, DOOR,
ROOF & VEHICLE SECURITY
L DRIVER CONTROLS
M ELECTRICAL &
POWER CONTROL
N DRIVER INFORMATION
& MULTIMEDIA
P MAINTENANCE
Heater & Air Conditioning System
Heater & Air Conditioning Control System
PWC Power Window Control System
Power Supply, Ground & Circuit Elements
Meter, Warning Lamp & Indicator
Audio, Visual & Navigation System
QUICK REFERENCE INDEX
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
M
Publication Number:
SM8E00-1J32E0E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст