Nissan Tiida C11. Instruction — part 1425
VTL-36
< ON-VEHICLE REPAIR >
[MANUAL AIR CONDITIONER]
INTAKE SENSOR
INTAKE SENSOR
Removal and Installation
INFOID:0000000001700349
REMOVAL
1.
Remove the evaporator. Refer to
VTL-41, "Removal and Installation of Evaporator"
CAUTION:
Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
2.
Remove the intake sensor (1) from the evaporator (2).
CAUTION:
Mark the position of intake sensor on the evaporator for
installation.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• Replace O-rings for A/C piping with new ones, and then apply compressor oil to it when installing it.
• Install the intake sensor in the same position as the original intake sensor.
• When recharging refrigerant, check for leaks.
ZJIA0798J
A/C UNIT ASSEMBLY
VTL-37
< ON-VEHICLE REPAIR >
[MANUAL AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
A/C UNIT ASSEMBLY
Removal and Installation
INFOID:0000000001696531
NOTE:
A LHD model shown, RHD model similar.
REMOVAL
1.
Use a recovery/recycling equipment (for HFC-134a) to discharge refrigerant. Refer to
2.
Drain coolant from cooling system. Refer to
CO-11, "Changing Engine Coolant"
(K9K).
3.
Remove cowl top cover. Refer to
EXT-20, "Removal and Installation"
.
4.
Remove lower dash insulator.
5.
Remove bolt (A), and then disconnect low-pressure flexible
hose (1) and high-pressure pipe (2) from evaporator.
CAUTION:
Cap or wrap the joint of the pipe with suitable material such
as vinyl tape to avoid the entry of air.
6.
Remove clamps (A), and then disconnect heater hoses (1) from
heater core.
A.
A/C unit assembly bolts
B.
Steering member bolts
C.
Steering column nuts
SJIA0648E
SJIA0644E
SJIA0645E
VTL-38
< ON-VEHICLE REPAIR >
[MANUAL AIR CONDITIONER]
A/C UNIT ASSEMBLY
7.
Remove console box assembly. Refer to
IP-11, "Removal and Installation"
.
8.
Remove instrument stay nuts (A) and harness clamps (B), and
then remove instrument stay (1).
9.
Disconnect thermo control amp. connector (1).
10. Remove instrument panel and pad. Refer to
IP-11, "Removal and Installation"
.
11. Remove side ventilator ducts. Refer to
VTL-48, "Removal and Installation"
.
12. Remove center ventilator ducts. Refer to
VTL-48, "Removal and Installation"
.
13. Remove side kicking plates. Refer to
INT-20, "Removal and Installation"
14. Disconnect the fuel filler door cable and the rear hatch door cable.
15. Remove A/C unit assembly bolts, steering member bolts, steering column nuts and harness clips.
16. Remove steering member, and then remove A/C unit assembly.
INSTALLATION
Installation is in the reverse order of removal.
• Fill the cooling system. Refer to
CO-11, "Changing Engine Coolant"
(HR16DE),
(K9K).
• Recharge the refrigerant.
CAUTION:
• Replace O-rings for A/C piping with new ones, and apply compressor oil when installing.
• When recharging refrigerant, check for leaks.
SJIA0646E
SJIA0647E
A/C unit assembly bolt
: 6.9 N·m (0.7 kg-m, 61 in-lb)
Steering member bolt
: 12 N·m (1.25 kg-m, 9 ft-lb)
Steering column nut
: Refer to
ST-9, "Removal and Installation"
.
A/C UNIT ASSEMBLY
VTL-39
< ON-VEHICLE REPAIR >
[MANUAL AIR CONDITIONER]
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
Disassembly and Assembly
INFOID:0000000001696532
1.
Blower case (right)
2.
Foot duct (right)
3.
Blower motor
4.
Sub ventilator·defroster door lever
5.
Sub ventilator·defroster door rod
6.
Ventilator·defroster door lever
7.
Ventilator·defroster door rod
8.
Intake door lever
9.
Ventilator·defroster door link
10.
Main link
11.
Thermo control amp. (TYPE 1*)
12. Heater pipe packing
13.
Lower blower case
14.
Heater pipe cover
15. Heater pipe clip
16.
Intake door link
17.
Blower fan resistor
18. Intake case (left)
19.
Center defroster duct
20.
Blower case (left)
21. Cover
22.
Cover
23.
Expansion valve cover
24. Foot door lever
25.
Foot door link
26.
Expansion valve
27. Air conditioner filter
28.
Evaporator cover
29.
Heater core
30. Spring
31.
Water valve rod
32.
Air mix door lever
33. Intake door
34.
Intake case (right)
35.
Foot duct (left)
36. Ventilator·defroster door
37.
Foot door
38.
Air mix door
39. Seal
40.
Expansion valve grommet
41.
O-ring
42. Evaporator
AWIIA0591ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст