Nissan Quest E52. Instruction — part 1028
SUNROOF MOTOR ASSEMBLY
RF-55
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
REAR SUNROOF : Exploded View
INFOID:0000000009650394
REAR SUNROOF : Removal and Installation
INFOID:0000000009650395
REMOVAL
CAUTION:
• Before removing sunroof motor, check that glass lid is fully closed.
• After removing sunroof motor, never attempt to rotate sunroof motor assembly as a single unit.
1.
Fully close glass lid.
2.
Remove headlining. (without rear display) Refer to
INT-35, "Removal and Installation"
.
3.
Remove roof console. Refer to
1.
Glass lid
2.
TORX bolt
3.
Side trim
4.
Rear sunroof bracket
5.
Rear drain hose
6.
Rear drain connector
7.
Rear display bracket
8.
Sunroof motor assembly
9.
Sunroof unit assembly
: Indicates that the part is connected at points with same symbol in actual vehicle.
JMKIA6144ZZ
RF-56
< REMOVAL AND INSTALLATION >
SUNROOF MOTOR ASSEMBLY
4.
Disconnect harness connector (A) from sunroof motor assembly.
5.
Remove sunroof motor assembly fixing screws (B), and then
remove sunroof motor assembly.
INSTALLAITON
1.
Move the sunroof motor assembly laterally by little so that the gear is completely engaged into the wire on
the sunroof unit assembly and mounting surface becomes parallel. Then secure the sunroof motor
assembly with screws.
2.
Install headlining. (without rear display) Refer to
INT-35, "Removal and Installation"
.
3.
Install roof console. Refer to
.
NOTE:
After installation sunroof motor, perform additional service. Refer to
RF-21, "REAR SUNROOF : Description"
JMKIA6152ZZ
SUNROOF UNIT ASSEMBLY
RF-57
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
SUNROOF UNIT ASSEMBLY
FRONT SUNROOF
FRONT SUNROOF : Exploded View
INFOID:0000000009650396
REMOVAL
DISASSEMBLY
1.
Glass lid
2.
TORX bolt
3.
Front sunroof bracket
4.
Center drain hose
5.
Side trim
6.
Front drain hose
7.
Front drain connector
8.
Sunroof motor assembly
9.
Sunroof unit assembly
: Metal clip
,
: Indicates that the part is connected at points with same symbol in actual vehicle.
JMKIA6143ZZ
RF-58
< REMOVAL AND INSTALLATION >
SUNROOF UNIT ASSEMBLY
FRONT SUNROOF : Removal and Installation
INFOID:0000000009650397
REMOVAL
CAUTION:
• Always work with a helper.
• Fully close the glass lid assembly, before removal, then never operate sunroof motor assembly after
removal.
• After removing sunroof motor assembly, never attempt to rotate sunroof motor assembly as a single
unit.
• When remove/install sunroof unit, use cloths to protect the seats and trim from damage.
• After installing the sunroof unit and glass lid, perform the leak test and check that there is no mal-
function.
1.
Remove headlining. Refer to
2.
Remove rear display. (with rear display) Refer to
AV-252, "Removal and Installation"
1.
Rear drain assembly
2.
Wind deflector
3.
Sunroof frame assembly
4.
Sunshade
5.
Sunshade stopper
JMKIA6148ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст