Nissan Quest E52. Instruction — part 667
SLIDE DOOR RAIL COVER
EXT-43
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
SLIDE DOOR RAIL COVER
Exploded View
INFOID:0000000009650519
Removal and Installation
INFOID:0000000009650520
REMOVAL
1.
Remove rear combination lamp. Refer to
EXL-113, "Removal and Installation"
2.
Fully open slide door.
3.
Remove slide door rail cover mounting bolt (A).
4.
Fully close slide door.
5.
Pull lower portion of slide door rail cover toward vehicle outer,
disengage mounting clips of slide door cover, and then remove
slide door rail cover.
CAUTION:
Apply protective tape (A) on the part to protect it from dam-
age.
INSTALLATION
1.
Clip
2.
Watertight clip
(With sponge washer)
3.
Bolt
4.
Slide door rail cover
: Always replace after every disassembly.
JMKIA6123ZZ
JMKIA6244ZZ
: Clip
JMKIA6245ZZ
EXT-44
< REMOVAL AND INSTALLATION >
SLIDE DOOR RAIL COVER
Note the following item, and then install in the reverse order of removal.
CAUTION:
Never reuse clip and bolt once they are removed
REAR SPOILER
EXT-45
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
REAR SPOILER
Exploded View
INFOID:0000000009650521
Removal and Installation
INFOID:0000000009650522
REMOVAL
1.
Remove back door upper finisher. Refer to
INT-49, "BACK DOOR UPPER FINISHER : Removal and
.
2.
Remove rear spoiler assembly mounting nuts.
3.
Insert a remover tool (A) between rear spoiler and back door
panel, and then cut double-sided tape using a cutter (B) while
lifting up rear spoiler.
CAUTION:
Apply protective tape (C) on the part to protect it from dam-
age.
4.
Disengage mounting clips of rear spoiler using a remover tool.
1.
Washer nozzle
2.
Rear spoiler assembly
3.
Grommet
4.
High-mounted stop lamp
5.
Double-sided tape
[t: 2.0 mm (0.079 in)]
: Clip
: Always replace after every disassembly.
: Vehicle front
JMKIA8275ZZ
: Clip
JMKIA6253ZZ
EXT-46
< REMOVAL AND INSTALLATION >
REAR SPOILER
5.
Disconnect harness connector of high-mounted stop lamp and rear washer tube.
6.
Remove rear spoiler assembly.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• Be careful not to wind up the lips of back door upper molding.
• Degrease mounting surface of rear spoiler.
• Never wash the vehicle with in 24 hours so as to keep adhesive.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст