Nissan Quest E52. Instruction — part 754
HAC-146
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONING]
IN-VEHICLE SENSOR
IN-VEHICLE SENSOR
Removal and Installation
INFOID:0000000009652597
REMOVAL
Front Side
1.
Remove instrument lower panel LH. Refer to
IP-14, "Removal and Installation"
.
2.
Remove fixing screw (A), and then remove in-vehicle sensor.
Rear Side
1.
Remove luggage side lower finisher RH. Refer to
INT-43, "LUGGAGE SIDE LOWER FINISHER :
.
2.
Remove fixing screw (A), and then disconnect harness connec-
tor.
3.
Remove intake sensor from rear A/C unit assembly.
INSTALLATION
Install in the reverse order of removal.
JMIIA1845ZZ
JMIIA1172ZZ
SUNLOAD SENSOR
HAC-147
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONING]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
SUNLOAD SENSOR
Removal and Installation
INFOID:0000000009652598
REMOVAL
1.
Disengage fixing pawls using a remover tool (A) as shown in the
figure.
CAUTION:
Apply protective tape (B) on the part to protect it from dam-
age.
2.
Disconnect sunload sensor harness connector, and then remove sunload sensor.
INSTALLATION
Install in the reverse order of removal.
: Pawl
JMIIA1847ZZ
HAC-148
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONING]
INTAKE SENSOR
INTAKE SENSOR
Removal and Installation
INFOID:0000000009652599
REMOVAL
1.
Remove evaporator assembly. Refer to
HA-52, "EVAPORATOR : Removal and Installation"
2.
Remove intake sensor from evaporator assembly.
INSTALLATION
Note the following items, and install in the reverse order of removal.
CAUTION:
• Replace O-rings with new ones. Then apply the compressor oil to them when installing.
• Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor
can be located in the same position.
• Never rotate the bracket insertion part when removing and installing the intake sensor.
• Check for leakages when recharging refrigerant. Refer to
EXHAUST GAS/OUTSIDE ODOR SENSOR
HAC-149
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONING]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
EXHAUST GAS/OUTSIDE ODOR SENSOR
Removal and Installation
INFOID:0000000009652600
REMOVAL
1.
Remove front grille. Refer to
EXT-18, "Removal and Installation"
2.
Remove mounting nut (A), and then remove exhaust gas/out-
side odor sensor.
3.
Disconnect exhaust gas/outside odor sensor connector (B).
INSTALLATION
Install in the reverse order of removal.
JMIIA1846ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст