Nissan March K13. Instruction — part 615

SR-38

< REMOVAL AND INSTALLATION >

DEPLOYMENT AND DISPOSAL

The battery must show voltage of 9.6 V or more.
Remove the battery from the vehicle and place it on dry wood blocks
approximately 5.0 m (16.4 ft) away from the vehicle.
• Wait 3 minutes or more after the vehicle battery is disconnected

before proceeding.

• Connect red clip of deployment tool (A) to battery positive terminal

and black clip to negative terminal.

Check that the polarity is correct. The right side lamp in the
tool, marked “deployment tool power”, should illuminate with a
green light. If the right side lamp illuminates red, reverse the
connections to the battery.

Deployment Tool Check

Press the deployment tool switch (C) to the ON position. The left
side lamp in the tool, marked “air bag connector voltage” should illu-
minate (B). If it does not illuminate, replace the deployment tool (A).

Air Bag Deployment Tool Lamp Illumination Chart (Battery Connected)

*: If this lamp illuminates red, the tool is connected to the battery incorrectly. Reverse the connections and check that the lamp illumi-
nates green.

DEPLOYMENT OF FRONT SEAT BELT PRE-TENSIONER (OUTSIDE OF VEHICLE)

Firmly grip pre-tensioner (1) in a vise (A) and cut off the web-
bing.

Connect deployment tool (SST: KV99106400) (A) and deploy-
ment tool adapter (SST: KV99110500) (B) yellow connector to
front seat belt pre-tensioner (1).

Connect red clip of deployment tool to battery positive terminal
and black clip to negative terminal (C).

The lamp on the right side of the tool, marked “deployment tool
power”, should illuminate green, not red.

Press the button on the deployment tool. The left side lamp on
the tool, marked “seat belt pre-tensioner connector voltage”, illu-
minates and the front seat belt pre-tensioner deploys.

CAUTION:

JMHIA0204ZZ

JMHIA0205ZZ

Switch operation

Left side lamp, green*

“AIR BAG CONNECTOR VOLTAGE”

Right side lamp, green*

“DEPLOYMENT TOOL POWER”

OFF

JMHIA0068ZZ

JMHIA0214ZZ

DEPLOYMENT AND DISPOSAL

SR-39

< REMOVAL AND INSTALLATION >

When deploying the front seat belt pre-tensioner, stand at least 5.0 m(16.4 ft) away from the front
seat belt pre-tensioner.

SEAT BELT PRE-TENSIONER : Disposal

INFOID:0000000005891465

DISPOSING OF AIR BAG MODULE AND SEAT BELT PRE-TENSIONER

Deployed air bag module and seat belt pre-tensioner are very hot. Before disposing of air bag module and
seat belt pre-tensioner, wait at least 30 minutes or more, and 10 minutes or more, respectively. Seal them in a
plastic bag before disposal.

CAUTION:

• Never apply water to a deployed air bag module or seat belt

pre-tensioner.

• Always use gloves when handling a deployed air bag module

or seat belt pre-tensioner.

• No poisonous gas is produced upon air bag module deploy-

ment. However, be careful not to inhale gas since it irritates
the throat and can cause choking.

• Never disassemble the air bag module and seat belt pre-ten-

sioner.

• Air bag module and seat belt pre-tensioner cannot be reused.
• Wash your hands clean after the work is complete.

SBF276H

SRC-1