Nissan Altima L32. Instruction — part 1192
REAR LOWER LINK & COIL SPRING
RSU-13
< ON-VEHICLE REPAIR >
C
D
F
G
H
I
J
K
L
M
A
B
RSU
N
O
P
ON-VEHICLE REPAIR
REAR LOWER LINK & COIL SPRING
Removal and Installation
INFOID:0000000004205681
Removal
1. Loosen the rear lower link bolt and nut from the suspension member side.
2. Support the rear lower link by placing a suitable jack under the knuckle.
3. Remove the rear lower link adjusting bolt and nut from the sus-
pension member side using power tool.
• Do not reuse the adjusting nut, use a new adjusting nut for
installation.
4. Slowly lower the jack to lower the rear lower link and coil spring.
5. Remove the upper rubber seat, coil spring, and lower rubber
seat from the rear lower link.
6. Remove rear lower link bolt and nut from the suspension mem-
ber side using power tool.
7. Remove the rear lower link.
Installation
Installation is in the reverse order of removal.
• Do not reuse the adjusting nut, use a new adjusting nut for installation.
• Check that the projecting part inside the upper rubber seat and the
bracket flange are attached as shown.
• Check that the projection part outside the upper rubber seat is
directed toward the front of the vehicle.
• Position the hollow of the lower rubber seat with the groove part of
the rear lower link.
• Install the coil spring so that the side with the two paint markers is
directed toward the lower side.
• Check the rear wheel alignment and adjust if necessary. Refer to
RSU-18, "Rear Wheel Alignment (Unladen*)"
.
LEIA0009E
LEIA0011E
RSU-14
< ON-VEHICLE REPAIR >
FRONT LOWER LINK
FRONT LOWER LINK
Removal and Installation
INFOID:0000000004205682
Removal
1. Remove the front lower link nut and bolt from the knuckle side
and the adjusting bolt and nut from the suspension member side
using power tools.
• Do not reuse the adjusting nut, use a new adjusting nut for
installation.
2. Remove the front lower link.
Installation
Installation is in the reverse order of removal.
• Do not reuse the adjusting nut, use a new adjusting nut for installation.
• Check the rear wheel alignment and adjust if necessary. Refer to
LEIA0008E
RADIUS ROD
RSU-15
< ON-VEHICLE REPAIR >
C
D
F
G
H
I
J
K
L
M
A
B
RSU
N
O
P
RADIUS ROD
Removal and Installation
INFOID:0000000004205683
Removal
1. Remove the rear suspension assembly. Refer to
RSU-12, "Removal and Installation"
2. Remove the radius rod using power tools.
Installation
Installation is in the reverse order of removal.
• Check the rear wheel alignment and adjust if necessary. Refer to
RSU-16
< ON-VEHICLE REPAIR >
REAR STABILIZER
REAR STABILIZER
Removal and Installation
INFOID:0000000004205684
Removal
1. Disconnect the stabilizer bar from connecting rod, using power tools.
2. Remove the stabilizer bar clamps and bushings using power
tools.
3. Remove the stabilizer bar.
Installation
Installation is in the reverse order of removal.
LEIA0050E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст