Nissan Frontier D22. Instruction — part 932
TF-34
REPAIR FOR COMPONENT PARTS
2.
Remove main gear bearing using puller and Tool, as shown.
Plug
Remove plug using a drift or suitable tool, as shown.
●
Always replace plug with a new one whenever it has been
removed.
INSPECTION
Gear, Shaft and Bearing
●
Check gears for excessive wear, chips or cracks.
●
Check shaft for cracks or wear.
●
Make sure bearings roll freely and are free from noise, cracks,
pitting or wear.
ASSEMBLY
Main Gear Bearing
1.
Press on main gear bearing.
SMT305A
SMT306A
SMT359A
SMT307A
REPAIR FOR COMPONENT PARTS
TF-35
C
E
F
G
H
I
J
K
L
M
A
B
TF
2.
Select and install snap ring with proper thickness.
Plug
●
Apply sealant to plug, then install using a drift or suitable tool, as
shown.
●
Use Genuine Anaerobic Liquid Gasket or equivalent. Refer
to
GI-42, "RECOMMENDED CHEMICAL PRODUCTS AND
Front Case
EDS0011P
SHIFT SHAFT OIL SEAL
Removal
Use a screwdriver to pry out old seal.
●
Be careful not to damage case.
●
Always replace seal with a new one whenever it has been
removed.
Installation
Install new shift shaft oil seal until flush with case.
●
Before installing, apply multi-purpose grease to seal lip.
Allowable clearance
between snap ring and
groove
: 0 - 0.15 mm (0 - 0.0059 in)
Available snap ring for
main gear bearing
ATF014
SMT309A
SMT310A
SMT311A
TF-36
REPAIR FOR COMPONENT PARTS
Front Case Cover
EDS0011Q
COVER OIL SEAL
Removal
Drive out old seal from inside of front case cover using a drift or suit-
able tool, as shown.
●
Be careful not to damage front case cover.
Installation
Install new front case cover oil seal until it stops using Tool, as
shown.
●
Before installing, apply multi-purpose grease to seal lip.
Bearing Retainer
EDS0011R
OIL CATCHER
Removal
Drive out oil catcher from inside of bearing retainer using a drift or
suitable tool, as shown.
●
Be careful not to damage bearing retainer.
Installation
Install oil catcher until it stops using a drift or suitable tool, as shown.
●
Be careful not to damage or distort oil catcher or bearing
retainer.
●
Before installing, apply multi-purpose grease to seal lip.
SMT312A
SMT313A
SMT314A
SMT315A
REPAIR FOR COMPONENT PARTS
TF-37
C
E
F
G
H
I
J
K
L
M
A
B
TF
Center Case
EDS0011S
CENTER CASE OIL SEAL
Removal
Remove center case oil seal using Tool, as shown.
Installation
Install center case oil seal using Tool, as shown.
Rear Case
EDS0011T
REAR OIL SEAL
Removal
Pull out rear oil seal using Tool, as shown.
Installation
Install new rear oil seal until it stops using Tool, as shown.
●
Before installing, apply multi-purpose grease to seal lip.
SMT863D
SMT864D
AMT094
SMT317A
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст