Nissan Maxima. Instruction — part 378
TRUNK LID OPENER SWITCH
DLK-231
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
TRUNK LID OPENER SWITCH
Removal and Installation
INFOID:0000000009471783
REMOVAL
1. Remove the instrument lower panel LH. Refer to
IP-19, "Removal and Installation"
.
2. Release pawls (A), and press trunk lid opener switch (1) front
side to remove from instrument lower panel LH.
INSTALLATION
Installation is in the reverse order of removal.
JMKIA0165ZZ
DLK-232
< REMOVAL AND INSTALLATION >
TRUNK OPENER REQUEST SWITCH
TRUNK OPENER REQUEST SWITCH
Removal and Installation
INFOID:0000000009471784
REMOVAL
1. Remove the license lamp finisher (1). Refer to
EXL-166, "Removal and Installation"
.
2. Remove the inner bracket screws (A) and inner bracket (2) from
license lamp finisher (1).
3. Remove the trunk lid request switch screw (B) and trunk lid
request switch (3).
INSTALLATION
Installation is in the reverse order of removal.
JMKIA0149ZZ
INTELLIGENT KEY BATTERY
DLK-233
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
INTELLIGENT KEY BATTERY
Removal and Installation
INFOID:0000000009471785
1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key.
2. Insert a suitable tool (A) wrapped with a cloth into the slit of the
corner and twist it to separate the upper part from the lower part.
CAUTION:
• Do not touch the circuit board or battery terminal.
• The key fob is water-resistant. However, if it does get wet,
immediately wipe it dry.
3. Replace the battery with new one.
4. Align the tips of the upper and lower parts, and then push them
together until it is securely closed.
CAUTION:
• When replacing battery, keep dirt, grease, and other for-
eign materials off the electrode contact area.
• After replacing the battery, check that all Intelligent Key
functions work normally.
PIIB6221E
Battery replacement
:Coin-type lithium battery (CR2032)
PIIB6222E
DLK-234
< REMOVAL AND INSTALLATION >
REMOTE KEYLESS ENTRY RECEIVER
REMOTE KEYLESS ENTRY RECEIVER
Removal and Installation
INFOID:0000000009471786
REMOVAL
1. Remove glove box assembly. Refer to
IP-20, "Removal and Installation"
2. Disconnect the harness connector from the remote keyless
entry receiver (1).
3. Remove the screw (a) and remote keyless entry receiver (1).
INSTALLATION
Installation is in the reverse order of removal.
ALKIA0019GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст