Nissan Maxima. Instruction — part 376
DOOR LOCK
DLK-223
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
• When installing do not reuse front door lock assembly screw. Always replace screw with new ones
when removed.
• When installing door key cylinder rod on the LH front door, be sure to rotate door key cylinder rod
holder until a click is felt.
• Check front door lock cable is properly engaged to outside handle bracket.
• After installation, check front door open/close, lock/unlock operation.
REAR DOOR LOCK
REAR DOOR LOCK : Exploded View
INFOID:0000000009471775
REAR DOOR LOCK : Removal and Installation
INFOID:0000000009471776
REMOVAL
1. Remove rear door finisher. Refer to
INT-21, "Removal and Installation"
.
2. Remove sealing screen.
3. Fully close the rear door glass.
1.
Outside handle escutcheon
2.
Rear gasket
3.
Striker
4.
Rear door lock assembly
5.
Inside handle
6.
Outside handle bracket
7.
Front gasket
8.
Outside handle
A. Bolt
Front
AWKIA1810GB
DLK-224
< REMOVAL AND INSTALLATION >
DOOR LOCK
4. Remove door side grommet, and loosen bolt from grommet
hole.
5. While pulling outside handle (1), remove outside handle
escutcheon (2).
6. While pulling outside handle (1), slide toward rear of vehicle (2)
to remove outside handle.
7. Remove front gasket and rear gasket.
8. While pulling outside handle bracket, slide toward rear of vehicle
to remove outside handle bracket.
9. Separate the outside handle cable connection from the outside handle bracket.
10. Remove door lock bolts.
11. Remove door lock assembly.
INSTALLATION
Installation in the reverse order of removal.
CAUTION:
• When installing do not reuse rear door lock assembly screw. Always replace screw with new ones
when removed.
• Check rear door lock cable is properly engaged to outside handle bracket.
JMKIA2095ZZ
JMKIA0560ZZ
PIIB5810E
JMKIA2303ZZ
DOOR LOCK
DLK-225
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
• After installation, check rear door open/close, lock/unlock operation.
DLK-226
< REMOVAL AND INSTALLATION >
TRUNK LID
TRUNK LID
TRUNK LID ASSEMBLY
TRUNK LID ASSEMBLY : Removal and Installation
INFOID:0000000009471777
CAUTION:
• Use two people when removing or installing trunk lid assembly due to its heavy weight.
• Use protective tape or shop cloths to protect surrounding components from damage during removal
and installation of trunk lid assembly.
REMOVAL
1. Remove trunk lid finisher. Refer to
INT-36, "Removal and Installation"
2. Disconnect the harness connectors in the trunk lid, remove the harness clips, and then pull the harness
out of the trunk lid.
3. Remove the nuts and the trunk lid assembly.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• After installation, check trunk lid open/close, lock/unlock operation.
• After installation, perform the trunk lid assembly adjustment procedure. Refer to
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст