Nissan Juke F15. Instruction — part 208
DLK-12
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
SYSTEM (POWER DOOR LOCK SYSTEM)
Setting change of Automatic Door Lock/Unlock Function
The lock operation setting of the automatic door lock/unlock function can be changed.
NOTE:
P range interlock door lock can be selected for M/T models, but automatic door lock/unlock function does not
operate.
With CONSULT
The ON/OFF switching of the automatic door lock function and the type selection of the automatic door lock/
unlock function can be performed at the WORK SUPPORT setting of CONSULT.
Without CONSULT
The automatic door lock function ON/OFF can be switched by performing the following operation.
1. Close all doors (door switch OFF)
2. Ignition switch: OFF
→ON
3. Press and hold the door lock and unlock switch for 5 seconds or more in the lock direction within 20 sec-
onds after turning the ignition switch ON.
4. The switching complete when the hazard lamp blinks.
*: This function does not operate on M/T models.
AUTOMATIC DOOR LOCK/UNLOCK FUNCTION (UNLOCK OPERATION)
The automatic door lock/unlock function is the function that unlocks all doors linked with the key position or
shift position. It has 2 types as per the following items.
IGN OFF Interlock Door Unlock*
1
All doors are unlocked when the power supply position is changed from ON to OFF.
BCM outputs the unlock signal to all door lock actuators when it detects that the power supply position is
changed from ignition switch ON to OFF.
P Range Interlock Door Unlock*
2
All doors are unlocked when shifting the selector lever from any position other than the P to P position.
BCM outputs the unlock signal to all door lock actuators when it detects that the ignition switch is in the ON
position and the shift signal received from TCM via CAN communication is shifted from any position other than
the P to P position.
Setting change of Automatic Door Lock/Unlock Function
The unlock operation setting of the automatic door lock/unlock function can be changed.
NOTE:
P range interlock door lock can be selected for M/T models, but automatic door lock/unlock function does not
operate.
With CONSULT
The ON/OFF switching of the automatic door lock/unlock function and the type selection of the automatic door
lock/unlock function can be performed at the WORK SUPPORT setting of CONSULT. Refer to
"DOOR LOCK : CONSULT Function (BCM - DOOR LOCK)"
.
Without CONSULT
The automatic door lock/unlock function ON/OFF can be switched by performing the following operation.
1. Close all doors below (door switch OFF)
2. Ignition switch: OFF
→ON
3. Press and hold the door lock and unlock switch for 5 seconds or more in the unlock direction within 20
seconds after turning the power supply position ON.
4. The switching is complete when the hazard lamp blinks.
*
1
: This function is set to ON before delivery.
*
2
: This function does not operate on M/T models.
OFF
→ ON
: 2 blinks
ON
→ OFF
: 1 blink
OFF
→ ON
: 2 blinks
ON
→ OFF
: 1 blink
SYSTEM (INTELLIGENT KEY SYSTEM)
DLK-13
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
SYSTEM (INTELLIGENT KEY SYSTEM)
INTELLIGENT KEY SYSTEM
INTELLIGENT KEY SYSTEM : System Diagram
INFOID:0000000012196582
INTELLIGENT KEY SYSTEM : System Description
INFOID:0000000012196583
• The Intelligent Key system is a system that makes it possible to lock and unlock the door locks (door lock/
unlock function) by carrying the Intelligent Key, which operates based on the results of electronic ID verifica-
tion using two-way communication between the Intelligent Key and the vehicle (BCM).
CAUTION:
The driver should always carry the Intelligent Key
• The settings for each function can be changed with CONSULT.
• If an Intelligent Key is lost, a new Intelligent Key can be registered. A maximum of 4 Intelligent Keys can be
registered.
• It is possible to perform a diagnosis on the system and register an Intelligent Key with CONSULT.
JMKIA6118GB
Function
Description
Refer
Door lock
Lock/unlock can be performed by pressing the request switch
Remote keyless entry
Lock/unlock can be performed by pressing the remote controller button of the In-
telligent Key
Key reminder
The key reminder buzzer sounds a warning if the door is locked with the key left
inside the vehicle
DLK-14
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
SYSTEM (INTELLIGENT KEY SYSTEM)
DOOR LOCK FUNCTION
DOOR LOCK FUNCTION : System Diagram
INFOID:0000000012196584
DOOR LOCK FUNCTION : System Description
INFOID:0000000012196585
When pressing the door request switch, it is possible to lock and unlock the door by carrying the Intelligent
Key.
OPERATION DESCRIPTION
• When the BCM detects that each door request switch is pressed, it activates the outside key antenna and
inside key antenna corresponding to the pressed door request switch and transmits the request signal to the
Intelligent Key. And then, check that the Intelligent Key is near the door.
• If the Intelligent Key is within the outside key antenna detection area, it receives the request signal and
transmits the key ID signal to the BCM via remote keyless entry receiver.
• BCM receives the key ID signal and compares it with the registered key ID.
• BCM transmits door lock/unlock signal and operates each door lock actuator. At the same time, BCM blinks
hazard warning lamp (lock: 2 times, unlock: 1 time) and sounds Intelligent Key buzzer (lock: 2 times, unlock:
1 time) as a reminder.
OPERATION CONDITION
If the following conditions are satisfied, door lock/unlock operation is performed if the door request switch is
operated.
Warning
If an action that does not meet the operating condition of the Intelligent Key sys-
tem is taken, the buzzer sounds to inform the driver
Engine start
The engine can be turned on while carrying the Intelligent Key
Interior room lamp control
Interior room lamp is controlled according to door lock/unlock state
Panic alarm
When Intelligent Key panic alarm button is pressed, horn sounds
Function
Description
Refer
JMKIA6137GB
SYSTEM (INTELLIGENT KEY SYSTEM)
DLK-15
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
*: Even with a registered Intelligent Key remaining inside the vehicle, door locks can be unlocked from outside of the vehicle with a spare
Intelligent Key as long as key IDs are different.
OUTSIDE KEY ANTENNA DETECTION AREA
The outside key antenna detection area of door lock/unlock function
is in the range of approximately 80 cm (31.50 in) surrounding the
driver, passenger door handles (1) and back door handle (2). How-
ever, this operating range depends on the ambient conditions.
SELECTIVE UNLOCK FUNCTION
Lock Operation
When an LOCK signal is sent from door request switch (driver side, passenger side or back door), all doors
are locked.
Unlock Operation
• When an UNLOCK signal from front door request switch (driver side) is transmitted, driver side door
unlocks. When another UNLOCK signal is transmitted within 60 seconds, all door unlocks.
• When an UNLOCK signal from front door request switch (passenger side) is transmitted, passenger side
door unlocks. When another UNLOCK signal is transmitted within 60 seconds, all door unlocks.
• When an UNLOCK signal from back door request switch is transmitted, back door unlocks. When another
UNLOCK signal is transmitted within 60 seconds, all door unlocks.
How to Change Selective Unlock Operation Mode
Selective unlock operation mode can be changed using CONSULT.
DLK-28, "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)"
HAZARD AND BUZZER REMINDER FUNCTION
During lock, unlock, operation by each request switch, the hazard warning lamps and Intelligent Key warning
buzzer will blink or honk as a reminder.
When doors are locked, unlocked by each request switch, BCM honks Intelligent Key warning buzzer as a
reminder and blinks.
Operating Function of Hazard and Buzzer Reminder
Hazard and buzzer reminder does not operate if ignition switch ON position.
How to Change Hazard and Buzzer Reminder Operation Mode
Hazard and buzzer reminder operation mode can be changed using CONSULT.
DLK-28, "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)"
AUTO DOOR LOCK FUNCTION
Each door request switch operation
Operation condition
Lock
• All doors are closed
• Panic alarm is not activated
• P position warning is not activated
• Intelligent Key is outside the vehicle
• Intelligent Key is within outside key antenna detection area
Unlock
• All doors are closed
• Panic alarm is not activated
• Intelligent Key is outside the vehicle
• Intelligent Key is within outside key antenna detection area *
JMKIA5569ZZ
Operation
Hazard warning lamp blinks
Intelligent Key warning buzzer honk
Unlock
Once
Once
Lock
Twice
Twice
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст