Nissan Juke F15. Instruction — part 244
DLK-156
< REMOVAL AND INSTALLATION >
[WITH INTELLIGENT KEY SYSTEM]
HOOD LOCK
2. Check that primary latch is securely engaged with primary striker when hood assembly is closed [free-fall
from approximately 200 mm (7.874 in) height].
CAUTION:
Never free-fall hood assembly from a height of 300 (11.811 in) mm or more.
3. While operating the hood opener carefully, check that the front end of the hood is lifted by approximately
20 mm (0.787 in) (A). Also, check that the hood opener returns to the original position.
4. Check that secondary latch is properly engaged with secondary striker [6.8 mm (0.268 in)] (B).
5. Check the hood lock lubrication condition. If necessary, apply
body grease to hood lock.
1.
Primary striker
2.
Primary latch
3.
Secondary latch
4.
Secondary striker
: Grease up point
JMKIA5673ZZ
JMKIA5674ZZ
FRONT DOOR LOCK
DLK-157
< REMOVAL AND INSTALLATION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
FRONT DOOR LOCK
Exploded View
INFOID:0000000012196734
DOOR LOCK
DOOR LOCK : Removal and Installation
INFOID:0000000012196735
REMOVAL
1. Remove front door glass and front door lower sash (rear). Refer to
GW-17, "Removal and Installation"
.
2. Remove inside handle. Refer to
DLK-158, "INSIDE HANDLE : Removal and Installation"
.
3. Disengage inside handle cable and lock knob cable from cable clip.
4. Remove outside handle bracket. Refer to
DLK-158, "OUTSIDE HANDLE : Removal and Installation"
5. Remove door lock assembly TORX bolts.
6. Disconnect door lock actuator connector, and then remove door lock assembly.
1.
Door key cylinder assembly (driver
side)
Outside handle escutcheon (passen-
ger side)
2.
Rear gasket
3.
Outside handle bracket
4.
TORX bolt
5.
Key rod (driver side)
6.
Door lock assembly
7.
Inside handle
8.
Outside handle
9.
Front gasket
10. Cable clip
: Pawl
: Vehicle front
: Always replace after every disassembly.
: N·m (kg-m, in-lb)
: Body grease
JMKIA5883GB
DLK-158
< REMOVAL AND INSTALLATION >
[WITH INTELLIGENT KEY SYSTEM]
FRONT DOOR LOCK
INSTALLATION
Note the following items, and install in the reverse order of removal.
CAUTION:
• Never reuse TORX bolt. Always replace it with a new one when it is removed.
• Check door open/close, lock/unlock operation after installation.
• Check door lock cable is properly engaged with outside handle bracket.
• Check door lock assembly for poor lubrication. Apply body
grease to door lock if necessary.
INSIDE HANDLE
INSIDE HANDLE : Removal and Installation
INFOID:0000000012196736
REMOVAL
1. Remove front door finisher. Refer to
INT-13, "Removal and Installation"
2. Remove inside handle mounting bolt (A).
3. Disengage inside handle (1) from door panel (2) while sliding
inside handle toward vehicle rear, and then separate inside han-
dle.
4. Disengage inside handle cable (3) and lock knob cable (2), and
then remove inside handle (1).
INSTALLATION
Note the following item, and install in the reverse order of removal.
CAUTION:
Check door open/close, lock/unlock operation after installation.
OUTSIDE HANDLE
OUTSIDE HANDLE : Removal and Installation
INFOID:0000000012196737
REMOVAL
1. Fully close the front door glass.
2. Remove front door finisher. Refer to
INT-13, "Removal and Installation"
: Grease up point
JMKIA5892ZZ
: Vehicle front
JMKIA5884ZZ
JMKIA5885ZZ
FRONT DOOR LOCK
DLK-159
< REMOVAL AND INSTALLATION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
3. Remove sealing screen.
NOTE:
Cut the butyl-tape so that some parts of the butyl-tape do not remain on the sealing screen, if the sealing
screen is reused.
4. Disengage lock holder (1), and then separate key rod (3) from
door lock assembly (2).(Driver side)
5. Disconnect harness connector of door antenna (1) and door
request switch (2) and remove harness clamp (3).
6. Remove grommet (1) of door side. Loosen, through grommet
hole, TORX bolt (2) that fixes door lock cylinder. (For passenger
side, TORX bolt fixes outside handle escutcheon.)
7. While pulling outside handle, remove door key cylinder assem-
bly (diver side) or outside handle escutcheon (passenger side).
JMKIA5886ZZ
: Vehicle front
JMKIA5887ZZ
JMKIA5888ZZ
JMKIA0560ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст