Lexus GS300/400 (2000 year). Service manual — part 70
BE0G1–08
I01374
Ignitioin Switch
Clock Assembly
Driver Side Junction Block
SRS ACC Fuse
Passenger Side
Junction Block
DOME Fuse
–
BODY ELECTRICAL
CLOCK
BE–229
2530
LOCATION
BE0G2–03
I04191
BE–230
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
2531
GARAGE DOOR OPENER SYSTEM
REGISTRATION PROCEDURE
1.
NEW CODE REGISTRATION
NOTICE:
If pressing the switch of the original transmitter to
register the code, the system might operate.
When registering the transmitter codes such as for
garage or gate, check that there is nobody around
those places then register.
(a)
Press the switch for the item to be registered for 20 se-
conds
HINT:
When transferring to registration mode, LED (red) blinks in 1 Hz
cycle.
(b)
In the condition of (a), bring the original transmitter to with-
in 1–inch area around the garage door opener and press
the switch. (code transmitting).
HINT:
When code registration completes correctly, LED (red) blinks in
5.6 Hz cycle.
I03487
GARAGE DOOR
OPENER SWITCH
LEARN MODE
LED
OPERATION
ORIGINAL
TRANSMITTER
PRESSED
ENTER
EXIT
ON
OFF
20 sec
LED flashes
at a rate of 1 Hz
LED flashes at a
rate of 5.6 Hz
PRESSED
ON
OFF
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
BE–231
2532
New code registration timing chart.
If a code can not be registered, observe the following condi-
tions.
HINT:
If the battery of original transmitter is consumed.
Press the switch of the transmitter repeatedly in registra-
tion mode, as some transmitters stop transmitting for 1 to
2 seconds.
This system is not applicable to the garage door opener
which had been made before 1982.
2.
CODE DELETION
(a)
Press the switches at both ends of garage door opener
simultaneously for 20 seconds.
HINT:
When transferring to deletion mode, LED (red) blinks in 6 Hz
cycle.
(b)
When releasing the switch within 10 seconds after trans-
ferring to deletion mode, all the registered codes will be
erased.
HINT:
Press the switch until blinking in 6 Hz cycle stops, so that the
default code for check is set.
I03488
LED
OPERATION
GARAGE DOOR
OPENER SWITCH
(Switch at either end)
ON
OFF
CLEAR/DEFAULT
MODE
PRESSED
LOAD DEFAULT
LED flashes at a rate of 6 HZ
10 SEC
20 SEC
PRESSED
ON
OFF
Enter in erase mode to erase all 3 channels
BE–232
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
2533
Code deletion timing chart
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст