Lexus GS300/400 (2000 year). Service manual — part 71
BE0G3–03
I01375
Garage Door Opener Switch
Engine Room No.1
Junction Block
ECU–B Fuse
Passenger Side
Junction Block
DOME Fuse
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
BE–233
2534
LOCATION
The vehicle shown in this illustration is ”GS400”.
All components of ”GS300” other than the ones used for engine are same as ”GS400”.
BE0G4–01
BE–234
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
2535
REMOVAL
1.
REMOVE FRONT PERSONAL LIGHT LENS
2.
REMOVE FRONT PERSONAL LIGHT
(a)
Remove the 3 screws.
(b)
Disconnect the 2 connectors.
3.
REMOVE GARAGE DOOR OPENER SWITCH
BE0G5–03
I04192
I04191
I04193
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
BE–235
2536
INSPECTION
1.
INSPECT GARAGE DOOR OPENER SWITCH
Press the switch and check that each LED (red) lights up.
Even if only one switch is found not to light up, replace it.
2.
INSPECT GARAGE DOOR OPENER REGISTRATION
AND TRANSMITTING
HINT:
Use the home link tester made by KENT MORE for this test.
As it is necessary to record the code of the hand held transmit-
ter, customer’s code will be erased. When the inspection com-
pletes, please register the customer’s again.
(a)
Check that the code of hand held transmitter for inspec-
tion can be recorded.
(See page
If the code can not be registered, replace garage door opener.
(b)
Press the switch which an inspection code has been reg-
istered for and check that LED (green) of the home link
tester lights up.
If the LED (green) does not light up, replace the garage door
opener.
I04194
Wire Harness Side
BE–236
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
2537
3.
INSPECT GARAGE DOOR OPENER SWITCH CIRCUIT
Disconnect the connector from the switch and inspect the con-
nector on the wire harness side, as shown.
Tester connection
Condition
Specified condition
1 – Ground
Constant
Continuity
2 – Ground
Constant
Battery positive voltage
If the circuit is not as specified, inspect the power source or wire
harness.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст