Dacia SuperNova (engine E7J). Service manual — part 96
EXTERNAL PROTECTIONS
55
55 - 2
DISMOUNTING
Disconnect the rear fog spotlights, from the rear wiring.
Dismount:
- the nuts (1) and the attachment screws (3) of the rear bumper (4) on the carriage body,
by means of lateral supports (2), respectively by the bumper ends on the rear wheels passage.
-the attachment nuts (7) of the counterblade (6) on the carriage body.
Detach the rear bumper (5).
REMOUNTING
Perform the dismounting operations in the reverse order.
REAR BUMPER
EXTERNAL PROTECTIONS
55
55 - 3
WORKING PROCEDURE
Smooth the margins of the exfoliated area (dry abrasive paper 220 grams; 400) and slightly
depolish the whole bumper.
Ungrease with extraction petrol.
Using a gun, spray on exfoliated areas, Primer (liability ground)
Apply by spraying on the exfoliated areas, fuller till equalization, then spray on a thin layer on
the whole bumper.
In case after 20 minutes of fuller layer exposing in the air, the applied Fuller film does not
presents painting defects, spray using a gun two layers, wet +wet enamel in the vehicle color.
If the film presents painting defects, remove them by grinding and depolish the rest of the
surface. The operation will be performed after 6 hours of air drying, and after 20-30 minutes
when there is the possibility of drying at 60gr. C.
NOTE
For this operation, the dismounting of the bumper is not necessary with the condition
that the areas, which might be exposed to the used materials, should be protected.
REAR BUMPER
FRONT/REAR BUMPER PAINTING/REPAINTING PROCEDURE
The necessary materials for the repainting operation are the following:
-Abrasive paper gr
220; 4001sheet/4 bumpers;
-Extraction petrol S27
0,05 kg./bumper;
-Gauze
0,05 mp./bumper;
-Primer P572-2
12
10-15 gr./bumper;
-Fuller P565-777
80 gr./ bumper ;
-Catalytic agent P850-1492
40 gr./bumper;
-Thinner
15 gr./bumper;
-Same color enamel
-For opaque
-opaque enamel S 5505
180gr./bumper
- catalytic agent S 3538
45gr./ bumper
-thinner S 4300
35 gr./bumper
-For metallic paint
-metal enamel S 5901
175 gr./bumper
-thinner S 5900
35 gr./bumper
-catalytic agent S 493242 65 gr./bumper
-lacquer thinner 362077
35 gr./bumper
- Lacrit lacquer 228050
30 gr./bumper
EXTERNAL ACCESSORIES
56
56 - 1
OUTSIDE ACCESSORIES
EXTERNAL REAR VIEW MIRROR
DISMOUNTING
Dismount the attachment screw (3) for the interior ornament (4) and release the ornament;
Dismount the cross piece (2) attachment screws (5) and the ornament (6), releasing so, the
outside rear view mirror (7).
REMOUNTING
Perform in the reverse order the dismounting operations.
AILERON
DISMOUNTING
Open the hatchback and disconnect the lamp
supply connectors (2).
Dismount the attachment screws (3) of the
aileron (1) on the hatchback.
Release the aileron.
REMOUNTING
Perform in the reverse order the dismounting
operations.
3
2
1
EXTERNAL ACCESSORIES
56
56 - 2
AILERON
DISMOUNTING
Open the hatchback and disconnect the lamp
supply connectors (2).
Dismount the attachment screws (3) of the
aileron (1) on the hatchback.
Release the aileron.
REMOUNTING
Perform in the reverse order the dismounting
operations.
3
2
1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст