Dacia SuperNova (engine E7J). Service manual — part 95
WINDOWS
54
54 - 1
WINDSCREEN AND HATCHBACK GLASS REPLACEMENT
The replacement of these glasses is performed in case they are broken, when they are not
according to the required overall dimensions or when they have manufacturing defects (image
distortions, cracks, etc).
PREPARING FOR MOUNTING
Position the gasket (2) around the glass (1)
and place the assembly on a protection plate.
Place in the gasket channel all around the
gasket frame; a cotton cord ( 4 ) of 3 – 4
mm diameter, leaving at its free ends(3)
about 20 cm of cord, and between the ends,
the distance shall not be more than 10 cm.
MOUNTING OF THE WINDSCREEN
Mount on the carriage body, the windscreen – cord - glass gasket assembly, so that the cord
ends are placed towards the inside of carriage body.
From the inside of the vehicle, successively draw each end of the cord, the drawing direction
being parallel with the glass surface, towards the surface inner part, perpendicular on the frame,
beginning with the lower part, in this way the gasket edge is lifted and then lowered on the frame.
At the outside, the gasket is seated by slightly and successively pressing it on glass, so that the
tightening is uniform on the whole windscreen contour and frame.
DISMOUNTING OF A BROKEN
GLASS
If the glass or part of it did not fall, the
dismounting and the cleaning of the window
gaskets by the pieces of the broken glass
will be easier to be made by sticking a sheet
of paper on each surface.
WINDSCREEN AND HATCHBACK GLASS
WINDOWS
54
54 - 2
54
WINDSCREEN AND HATCHBACK GLASS
The cord must be always removed through the upper part of the windscreen.
Each time a windscreen is mounted, ensure the uniform setting of the whole assembly on the
carriage body by tapping several times with a rubber hammer, on the edge of the glass frame.
NOTE
Do not tap the glass on corners and on the two vertical sides.
After the windscreen mounting check out carefully the uniformity of the whole assembly and
then its water-proofing by splashing with a jet of water.
WINDOWS
54
54 - 3
Dismount the luggage compartment table.
Disconnect the mass connection and the
hatchback defrosting supply connection.
Remove the glass together with the gasket,
by pushing it from the inside of the vehicle.
Clean the gasket and place the glass in its
new gasket.
The mounting of the hatchback glass – gasket
assembly, is performed in the same way with
the windscreen mounting.
HATCHBACK GLASS REPLACEMENT
EXTERNAL PROTECTIONS
55
55 - 1
REMOUNTING
Perform in the reverse order the dismounting operations.
DISMOUNTING
Disconnect the fog projectors.
Dismount:
-the attachment nut (1) of the front bumper (2) on the carriage body
-the attachment screws (3) and the cage nuts (5) of the bumper on the front cross bar.
-the lateral supports (4) are fixed by nuts on the iron core mounted in the front bumper.
FRONT BUMPER
1
5
4
1
3
2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст