SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 225
5
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
RK STICS
STAVIC - 2004.09
2C
Door lock
Auto door unlock
Front room lamp
Time lag power window control
Parking brake warning
Tail lamp auto cut (battery saver)
Theft deterrent alarm
Panic alarm operating only
(ON: IGN S/W in)
Headlamp control (escort)
3. DESCRIPTIONS
Below table shows the major differences compared to the previous vehicle model before year 2004. For whole functions
and details, refer to corresponding section.
The door unlock output is sent to all doors once for 0.5 seconds when the “LOCK”
signal is inputted into unit within 0.5 seconds after closing the driver’s or
passenger’s door. This is regardless of key in or key out. It is to prevent the
doors from locking due to impact when the door is closed.
Previously, G-sensor in STICS outputs auto door unlock signal if the vehicle
collides over 15 km/h of vehicle speed. However, the air bag system is installed
in this vehicle as a basic equipment. When a collision, the “Auto Door Unlock”
function is activated by using a collision signal from the air bag module.
1. When receiving the unlock signal from remote control key with the door
closed, the front room lamp comes on for 30 seconds.
2. When receiving the unlock signal again during the time lagging operation,
another 30 seconds will be extended from unlock point.
The power window can be operated for 30 seconds after removing the ignition
key from key switch. This lagging operation stops when closing the door.
When the vehicle speed signal is inputted with the parking brake applied, the
warning light blinks and the chime buzzer in ICM box continuously sounds for 0.
6 seconds with 0.3 seconds of pausing time (when driving over 10 km/h of vehicle
speed for more than 2 seconds).
1. Turns on or off the tail lamp relay according to the tail lamp switch
operations.
2. The tail lamp relay is turned off (auto-cut) when removing the ignition key
and opening and closing the door while the tail lamp switch is turned on.
The hazard warning relay in ICM box outputs when the remote control key is
operated or the theft deterrent alarm is activated. At this time, separate warning
horn sounds.
1. The theft deterrent horn sounds for 27 seconds when receiving the panic
signal from the remote control key.
2. The panic alarm is turned off when receiving any signal from the remote
control key during the panic alarm operation.
3. This function works under armed mode.
1. The headlamp control supplies the power to headlamp relay for 20 seconds and
turns off when receiving the escort signal from the remote control key with the
ignition key off (if the escort signal is inputted again, it will be extended once for
20 seconds). However, the power supply and output is activated only when the
vehicle is in armed mode activated by remote control key.
2. The headlamp relay output is turned off immediately after receiving the
remote control lock signal during its operation (however, signals other than
lock signal from remote control key will be ignored).
3. The headlamp relay output is immediately turned off when the key is turned
to “ON” position during its operation (this function is also activated under
remote starting).
Item
RK STICS
6
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
RK STICS
STAVIC - 2004.09
2C
4. CONNECTOR ARRANGEMENT (UNIT)
Description
Hood switch
Rear LH/RH door switch
Seat belt warning light
Wiper motor relay (parking)
Vehicle speed signal
Tailgate switch
Tail lamp switch
Passenger’s door lock switch
Passenger’s door unlock switch
Diagnosis (KWP 2000)
Rear door lock switch
Washer switch
Intermittent auto switch
Door opening indication
Intermittent volume
Key hole illumination
Headlamp relay
NO.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
NO.
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
Status
Output
Output
Output
Output
Input
Output
Output
Output
Input
Output
Output
Output
Output
Output
Output
Output
Input
Input
Output
Input
Input
Input
Input
Input
Input
Input/Output
Output
Input
Input
Output
Input
Input
Input
Status
Input
Input
Output
Input
Input
Input
Input
Input
Input
Input/Output
Input
Input
Input
Output
Input
Output
Output
Description
Wiper relay (HI)
Tailgate heated glass/outside rearview mirror relay
Driver’s door unlock
Coding
Door lock
ALT_D
Power window relay
Ground
Headlamp relay
Door unlock
Passenger’s door lock switch
Chime buzzer (in ICM box)
Front room lamp
Wiper relay (LO)
Tail lamp relay
V+
Engine start relay
Ground
Theft deterrent horn
Rear room lamp
IGN 2
IGN 1
Parking brake warning light
Tailgate glass and outside rearview mirror heated glass
Seat belt switch
Rain sensor input
Key reminder switch
Tailgate lock switch
Driver’s door lock switch
Hazard flasher relay (in ICM box)
Theft deterrent alarm selection switch
Rain sensor output
Parking brake switch
Driver’s door switch
Passenger’s door switch
7
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
RK STICS
STAVIC - 2004.09
2C
5. SPECIFICATIONS
1) Electrical Performance
2) Chattering of Input Signals
1. Vehicle speed input:
The vehicle speed calculating time is 1.0 seconds. The elapsed time of 1.5 seconds after IGN 1 switch :ON” is not
included.
2. 20 ms target input:
Wiper motor A/S (parking) terminal
3. 100 ms target input switch
All switches except wiper motor A/S (parking) terminal
3) Time Tolerance
1. If not indicated, time tolerance will be ± 10%.
However, if less than 500 ms, time tolerance will be ± 50 ms.
2. The time indicated in each function does not include chattering processing time from switch input changing point.
Rated voltage
Operating voltage
Operating temperature
Reserved temperature
Max. operating humidity
Resistible voltage
Insulating resistance
Parasitic current
Voltage drop
Item
Requirement
DC 12 V
DC 9~16 V
-30°C ~ +80°C
-40°C ~ +85°C
95%
24 V
No heat and fire due to the
current leaks.
below 4.0 mA
(below 6.0 mA)
below 1.2 V
below 2.0 V
Remark
Should operate normally within this range.
Confined with PCB, waterproof and coating that requires
the insulation.
IGN = OFF, Full output load = OFF, 90 seconds (after
received the signals), No input changes for 2 seconds
Pin no. 8 and 2, 3, 5, 7, 10, 12, 13, 15, 19, 20, 23, 40, 47,
51, 53, 54
Pin no. 8 and 9, 13, 15, 23, 40, 51, 53
8
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
RK STICS
STAVIC - 2004.09
2C
IGN 1
IGN 2
ALT_D
Key reminder (door ajar warning switch)
Driver’s door switch
Passenger’s door switch
Rear door switch
Tailgate switch
Central door lock switch
Central door unlock switch
Driver’s door lock/unlock switch
Passenger’s door lock/unlock switch
Rear door lock/unlock switch
Tailgate lock/unlock switch
-
-
Hood switch
Tailgate switch
Defogger switch
Seat belt switch
Parking brake switch
Washer switch
Intermittent switch
Intermittent volume
Wiper motor (parking)
Rain sensor unit input
Rain sensor unit output
Hazard warning flasher selection switch
Collision sensor
Speed sensor
Coding
Diagnosis (K-Line)
1
2
3
4
5
6
7
8
9
10
11
12
13
-
-
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
ON = BAT (IGN “ON” or “START”)
ON = BAT (IGN “ON”)
ON = BAT equivalent (engine running)
IGN = BAT (Key in)
OPEN = GND
OPEN = GND
OPEN (one of rear seat) = GND
CLOSE (one of rear seat) = OPEN
OPEN = GND
ON = GND
ON = GND
LOCK = OPEN, UNLOCK = GND
LOCK = OPEN, UNLOCK = GND
UNLOCK (one of rear seat) = GND
LOCK (one of rear seat) = OPEN
LOCK = OPEN, UNLOCK = GND
-
-
OPEN = GND
ON = GND
ON = GND
Fastened = OPEN, Unfastened = GND
ON = GND (applied)
ON = GND
ON = GND
0
Ω ~ 50 kΩ (for intermittent wiper)
ON = GND
ON = GND (during sending from rain sensor)
ON = GND (during sending from RK STICS)
ON = GND
ON = 200 ms output (LOW)
Vehicle speed signal (OPEN COLLECTOR)
ON = BAT
ON = BAT (during Installation or
communication)
BAT = Battery
RK Stics
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст