SsangYong Rexton. Service manual — part 378
SSANGYONG Y200
1B3-88 DIESEL ENGINE MECHANICAL
FLYWHEEL RING GEAR
Preceding Work:
Removal of flywheel
1 Ring Gear
2 Flywheel
a Centering Collar Diameter
YAD1BFX0
DIESEL ENGINE MECHANICAL 1B3-89
SSANGYONG Y200
YAD1BFY0
YAD1BFZ0
YAD1BG00
YAD1BG10
Tools Required
001 589 53 21 00
Dial Gauge
363 589 02 21 00
Dial Gauge Holder
Replacement Procedure
1. Drill a hole into the ring gear (1) (arrow) and snap
with a chisel.
2. Thoroughly clean the collar surfaces of ring gear.
5. Install the new ring gear (1) onto the flywheel (2)
by using a drift.
4. Heat up the new ring gear up to 220°C (428°F) by
using a heating device.
Notice: Use temperature measuring chalk.
3. Measure diameter (a) of centering collar.
Diameter ‘a’
275 + 0.5 mm
Notice: If out of standard, replace the flywheel.
SSANGYONG Y200
1B3-90 DIESEL ENGINE MECHANICAL
YAD1BG20
6. Measure axial runout of ring gear (1) on a surface
plate using dial gauge 001 589 53 21 00 and dial
gauge holder 363 589 02 21 00.
Notice: For correct measurement, put the flywheel
on the flat measuring board.
Limit
Max. 0.4 mm
DIESEL ENGINE MECHANICAL 1B3-91
SSANGYONG Y200
TIMING DEVICE AND VALVE
VALVE TAPPETS
Preceding Work:
Removal of camshaft
1 Valve Tappet
2 Cylinder Head
3 Oil Gallery
4 Seal . . . . . . . . . . . . . . Replace
5 Screw Plug
YAD1BG30
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст