SsangYong Rexton. Service manual — part 371
SSANGYONG Y200
1B3-60 DIESEL ENGINE MECHANICAL
YAD1BDU0
YAD1BDV0
YAD1BDW0
8. Remove the washer and bolt.
9. Remove the hub by using a puller 103 589 00 33
00.
10. Pull out the radial seal (1) and be careful not to
damage the sealing surface of timing case cover.
DIESEL ENGINE MECHANICAL 1B3-61
SSANGYONG Y200
YAD1BDX0
YAD1BDY0
YAD1BDZ0
YAD1BE00
Installation Procedure
1. Install the hub.
Notice: Exactly align the woodruff key and the
groove of hub (arrow).
2. Install the washer and tighten the bolt.
Installation Notice
3. Install the vibration damper.
Notice: Exactly align and insert onto the straight
pin.
4. Install the crankshaft belt pulley.
Installation Notice
Align the alignment marks.
Tightening Torque
200 N•m (148 lb-ft)+ 90°
Tightening Torque
23 N•m (17 lb-ft)
SSANGYONG Y200
1B3-62 DIESEL ENGINE MECHANICAL
;;;;
;;;;
;;;;
;;;;
;;;;
;;;;
YAD1BE10
YAD1BE20
YAD1BE40
5. Install the timing sensor bracket.
Refer to “TDC Setting” in this section.
6. Install the cooling fan pulley.
Installation Notice
7. Install the cooling fan.
8. Install the fan belt.
9. Remove the engine lock 602 589 00 40 00.
10. Throughly clean the mounting bore of the radial
seal.
11. Coat a little oil on the sealing lip of new radial (1)
and contact surface.
Notice: Don’t use grease.
12. Install the radisl seal (1) by using a sleeve 601
589 03 14 00 (4).
Notice: Align the groove of sleeve and woodruff
key (arrow).
Tightening Torque
10 N•m (89 lb-in)
YAD1BE30
Notice: The sealing lip of the repair radial seal is
offset to the inside by 2 mm to ensure that is does
not run in any groove which the standard radial
seal may have left on the crankshaft flange.
A Standard Radial Seal
B Repair Radial Seal
DIESEL ENGINE MECHANICAL 1B3-63
SSANGYONG Y200
FLYWHEEL AND CRANKSHAFT END COVER
Preceding Work:
Removal of the transmission
Removal of the clutch
YAD1BE50
1 Crankshaft Flange
2 End Clver . . . . . . . .. Clean Loctite 573
3 Bolt . . . . . . 10 N•m (89 lb-in) Loctite 573
4 Radial Seal . . . . . . . . . . . Replace
5 Dowel Sleeve
6 Bolt . . . . . . 10 N•m (89 lb-in) Loctite 573
7 Straight Pin
8 Flywheel (Manual Transmission)
9 12-Sided Stretch Bolt
. . . . . . . Check, 45 N•m (33 lb-ft)+ 90°
10 Drive Plate (Automatic Transmission)
11 Flywheel (Automatic Transmission)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст