Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 392
1
1
2
3
Is the resistance greater than 5 ohms?
Yes
REPAIR the high resistance circuit. For additional information, refer to the wiring diagrams. CLEAR the DTC. TEST the
system for normal operation.
No
GO to C7
.
C7: CHECK THE J-GATE SIGNAL INPUT WIRES FOR CONTINUITY (2 RANGE).
Measure the resistance between IP14 pin 14 (R) and JB131 pin 08 (R).
Is the resistance greater than 5 ohms?
Yes
REPAIR the high resistance circuit. For additional information, refer to the wiring diagrams. CLEAR the DTC. TEST the
system for normal operation.
No
GO to C8
.
C8: J-GATE SIGNALS FUNCTIONALITY
If tests between C1 and C7 have been successfully completed and the fault is still present, INSTALL a new J-Gate.
CLEAR the DTC.
TEST the system for normal operation.
Does the system function correctly?
Yes
No further action required.
No
Contact dealer technical support for advice on possible module.
Published: 11-May-2011
Automatic Transmission/Transaxle External Controls - Vehicles With: 5-Speed
Automatic Transaxle - JATCO - Selector Lever Cable Adjustment
General Procedures
Setting Procedure-All Vehicles
1. Apply the parking brake.
2. Apply the footbrake.
3. Turn the ignition switch to position II.
4. Move the gear selector lever to 'N'.
5. Raise and support the vehicle.
For additional information, refer to Section
100-02 Jacking and Lifting
.
6. Remove the gear selector cover plate.
7. Loosen the gear selector cable retaining bolt.
Vehicles Built up to VIN D15360
• NOTE: Before starting the 'J' gate setting procedure, make sure the vehicle is cold, or has been left to cool for at least two hours.
1. Using the corner of the grey feature line that follows the edge of the 'J'
gate as a datum, use a rule and move the gear selector forwards or
back two millimeters.
All Vehicles
• NOTE: Before starting the 'J' gate setting procedure, make sure the vehicle is cold, or has been left to cool for at least two hours.
1. NOTE: Make sure the transmission is in neutral.
Fully tighten the cable retaining bolt
Tighten to 5Nm.
2. Install the gear selector cover plate.
Tighten to 10Nm.
3. Check for correct operation. If setting is incorrect, repeat the above
steps until correct operation is achieved.
Published: 11-May-2011
Automatic Transmission/Transaxle External Controls - Vehicles With: 5-Speed
Automatic Transaxle - JATCO - Selector Lever Cable and Bracket
Removal and Installation
Removal
1. NOTE: To move the gear selector lever, the ignition must be in the RUN
position, with the foot brake pressed.
Move the gear selector lever to "N" position.
2. Remove the center console right-hand side trim panel.
3. Release the gear selector cable locking pin.
4. Remove the center console side retaining screw.
5. Detach the gear selector cable from the J-gate.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст