Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 393
6. Disconnect the gear selector cable from the J-gate.
7. Detach the gear selector cable grommet.
8. Raise and support the vehicle. For additional information, refer to
Section
100-02 Jacking and Lifting
.
9. Detach the exhaust heat shield.
10. Remove the gear selector cable shield.
11. Detach the gear selector cable bracket.
12. Disconnect the gear selector cable.
13. Remove the gear selector cable from the gearbox mounting bracket.
1. Pull out the locking pin.
2. Remove the gear selector cable from the gearbox mounting
bracket.
14. Lower the vehicle.
15. Remove the selector cable.
Installation
1. To install, reverse the removal procedure.
Tighten to 10 Nm.
2. Tighten to 10 Nm.
Published: 11-May-2011
Automatic Transmission/Transaxle External Controls - Vehicles With: 5-Speed
Automatic Transaxle - JATCO - Selector Lever Assembly
Removal and Installation
Removal
1. NOTE: To move the selector lever, the ignition must be in the RUN
position, with the foot brake pressed.
Move the selector lever to the 'N' position.
2. Remove the floor console.
For additional information, refer to:
Floor Console
(501-12 Instrument
Panel and Console, Removal and Installation).
3. Disconnect the electrical connector.
4. NOTE: The floor console bracket cannot be removed at this stage.
Remove the floor console bracket retaining screws.
5. Release the selector lever cable locking pin.
6. Disconnect the selector lever cable from the selector lever.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст