Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 116
20. Attach the power steering high pressure pipe.
Vehicles with high intensity discharge headlamps
21. Attach the link rod to the headlamp leveling sensor.
All vehicles
22. Connect the power steering control valve actuator electrical connector
(if equipped).
23. NOTE: Right-hand shown, left-hand similar.
Connect tie-rod end ball joints.
1. Attach both tie rod ends to previously noted positions.
2. Tighten tie rod locking nut.
Right-hand drive vehicles
24. Install the right-hand wheel arch liner access cover.
All vehicles
25. Carry out steering system bleed procedure.
For additional information, refer to:
Power Steering System Filling
(211-00 Steering System - General Information, General Procedures).
26.
CAUTION: Make sure the steering column coupling is installed
with the vehicle on its wheels. Failure to follow this instruction may result
in damage to the vehicle.
Install the steering column coupling.
For additional information, refer to:
Steering Column Coupling
(211-04
Steering Column, Removal and Installation).
27. NOTE: If the steering gear is being replaced for leakage or noise
related issues and there is no evidence of fluid contamination, there is no
need to replace the reservoir.
In some cases where the fluid clearly contains particulate matter, and
the system continues to function, flush the system with fresh fluid and
replace the reservoir, as there is the possibility that the reservoir
internal filter may be damaged or faulty.
28. Using the Jaguar approved diagnostic system, configure the steering
angle sensor.
Published: 11-May-2011
Steering Linkage -
Torque Specifications
Description
Nm
lb-ft
lb-in
Tie-rod end retaining nut
35
26
-
Tie-rod end lock nut
40
30
-
W heel nuts - Vehicles with steel wheels
80
59
-
W heel nuts - Vehicles with aluminium wheels
103
76
-
Published: 11-May-2011
Steering Linkage - Steering Linkage
Description and Operation
Item
Part Number
Description
1
—
Steering gear
2
—
Tie-rod end boot
3
—
Tie-rod
4
—
Tie-rod end
5
—
W heel hub assembly
6
—
Tie-rod end retaining nut
7
—
Tie-rod end lock nut
The left and right-hand tie-rod assemblies:
Transmit steering forces from the steering gear to the wheel hubs.
Provide front road wheel toe setting by adjustment of the threaded outer tie-rod ends.
• NOTE: Steering geometry adjustments must only be carried out with the vehicle on turn plates to allow the wheels to move during
adjustment.
The left and right-hand steering rack boots:
Are installed between the steering rack and the tie-rod ends.
Are of the concertina type.
Retain lubricant and prevent the ingress of foreign matter.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст