Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 117
Published: 11-May-2011
Steering Linkage - Steering Linkage
Diagnosis and Testing
For additional information, refer toSection
211-00 Steering System - General Information
.
Published: 11-May-2011
Steering Linkage - Steering Gear Boot
Removal and Installation
Removal
1. Remove the tie-rod end. For additional information, refer to procedure in
this section:
Tie Rod End
2. Remove the steering gear boot.
1. Remove and discard the steering gear boot retaining clamp.
2. Detach the steering gear boot retaining clamp.
3. Remove the steering gear boot.
Installation
1.
CAUTION: Make sure the steering gear is clean before installing
the boot.
To install, reverse the removal procedure.
Install the steering gear boot using a new retaining clamp.
Published: 11-May-2011
Steering Linkage - Tie Rod End
Removal and Installation
Special Tool(s)
Seperator, Ball Joint
204-192 (JD-219)
Removal
1. Remove the wheel and tire. For additional information refer to Section
204-04 W heels and Tires
.
2. Loosen the tie-rod end lock nut.
3. Remove the tie-rod end retaining nut.
4. NOTE: W hen the tie-rod end is seperated from the wheel hub assembly,
the ball joint seal should be protected to prevent damage.
Using the special tool, detach the tie-rod end.
5. NOTE: Make a note of the number of turns required to remove the
tie-rod end.
Remove the tie-rod end.
Installation
1. NOTE: Make sure the tie-rod end is installed on the tie-rod by the same
amount of turns used to remove it.
To install, reverse the removal procedure.
Tighten to 40 Nm.
2. Tighten to 35 Nm.
3. Check the toe adjustment. For additional information, refer to Section
204-00 Suspension System - General Information
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст