Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 64
Published: 11-May-2011
Rear Drive Halfshafts -
Lubricants, Fluids, Sealers and Adhesives
Item
Specification
Constant velocity (CV) grease
Olistamoly LN 584 LO
Fill Capacities
Description
Grams
Grease for inner CV joint boot
90
Grease for inner CV joint
90
Grease for outer CV joint boot
90
Grease for outer CV joint
90
Published: 11-May-2011
Rear Drive Halfshafts - Rear Drive Halfshafts
Description and Operation
Rear Drive Halfshafts
Item
Part Number
Description
1
—
Outer constant velocity (CV) joint
2
—
Anti-lock brake system (ABS) ring
3
—
Outer CV joint boot
4
—
Inner CV joint boot
5
—
Seal protector
6
—
Spring clip
7
—
Inner CV joint
8
—
Barshaft
The rear drive halfshafts are of unequal lengths and both the inner CV joint and outer CV joints are of the plunger type.
The outer CV joints are fitted with an ABS ring which is continuously monitored by the wheel speed sensor.
The inner and outer CV joints are linked by a solid barshaft. The inner CV joints are retained in the differential with the aid of a spring clip.
The inner CV joints are fitted with plastic seal protectors to protect the halfshaft oil seals located in the differential from debris.
Due to the unique construction of the rear drive halfshafts they are not a serviceable item. If a problem occurs the halfshaft must be
replaced as a complete unit.
Handling Rear Drive Halfshafts
The following points should be observed when handling rear drive halfshafts:
Do not pull on the CV joints
Do not allow the CV joints to exceed 18 degrees of travel
Check polished surfaces and splines for damage
Do not allow the CV joint boots to come into contact with sharp edges, hot vehicle components or the exhaust system
Do not drop the rear drive halfshafts, this may cause damage to the splined sections of the CV joints, the threaded sections of the
CV joints or the interior of the boots which may not be visible
Do not support the rear drive halfshaft by holding the CV joint alone
Underbody Protection and Corrosion Prevention
The CV joint boots should be covered during application of underbody protection or corrosion prevention. Foreign matter on the CV boots
may cause premature ageing of the material. Foreign material on the rear drive halfshafts may cause imbalance.
Published: 11-May-2011
Rear Drive Halfshafts - Rear Drive Halfshafts
Diagnosis and Testing
For additional information, refer to Section
205-00 Driveline System - General Information
.
Published: 11-May-2011
Rear Drive Halfshafts - Rear Halfshaft
Removal and Installation
Special Tool(s)
Remover, Axle Shaft Oil Seal
308-208
Installer, Oil Seal
204-264
Removal
1. Remove the wheel knuckle.
For additional information, refer to:
Wheel Knuckle
(204-02 Rear
Suspension, Removal and Installation).
2. Remove the halfshaft.
3. Using the special tool, remove and discard the axle shaft oil seal.
Installation
1. Using the special tool, install the axle shaft oil seal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст