Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 63
Published: 11-May-2011
Front Drive Halfshafts - Intermediate Shaft
Removal and Installation
Removal
All vehicles
1. Remove the right-hand halfshaft.
For additional information, refer to
Halfshaft RH
in this section.
Vehicles with automatic transmission
2. Drain the automatic transmission fluid. For additional information, refer
to Section
307-01A Automatic Transmission/Transaxle
/
307-01B
Automatic Transmission/Transaxle
.
Vehicles with manual transmission
3. Drain the manual transmission fluid.
For additional information, refer to Section
308-03 Manual
Transmission/Transaxle
.
All vehicles
4.
CAUTION: Before removing the bearing carrier retaining bolts,
identify their correct position. Failure to follow this procedure will result in
damage to the vehicle.
Remove the intermediate shaft bearing carrier retaining bolts.
Remove the branch pipe heat shield.
5. Remove the intermediate shaft.
Installation
All vehicles
1.
CAUTION: Make sure the intermediate shaft splines are located
fully. Do not use excessive force when engaging the intermediate shaft
into the transmission.
Install the intermediate shaft.
2.
CAUTION: Before installing the bearing carrier retaining bolts
make sure that the bearing carrier is located in the same position that it
was removed from, failure to follow this procedure will result in damage to
the vehicle.
Install the branch pipe heat shield.
Tighten to 25 Nm.
Vehicles with automatic transmission
3. Refill the automatic transmission system. For additional information,
refer to Section
307-01A Automatic Transmission/Transaxle
/
307-01B
Automatic Transmission/Transaxle
.
Vehicles with manual transmission
4. Refill the manual transmission.
For additional information, refer to Section
308-03 Manual
Transmission/Transaxle
.
All vehicles
5. Install the right-hand halfshaft.
For additional information, refer to
Halfshaft RH
in this section.
Published: 11-May-2011
Front Drive Halfshafts - Outer Constant Velocity (CV) Joint Boot
Removal and Installation
Removal
1. Remove the front halfshaft. For additional information, refer to
Halfshaft LH
. For additional information, refer to
Halfshaft RH
.
2.
CAUTION: Use suitable protective covers to protect the barshaft.
Using a suitable clamp, secure the front halfshaft
3. Remove the outer constant velocity (CV) joint retaining clips.
Remove and discard the retaining clips.
4. Detach the outer CV joint boot.
Remove and discard the grease.
5.
CAUTION: Do not damage the bearing retainer.
• NOTE: The outer CV joint is retained to the shaft by a spring clip.
Using a suitable brass drift, remove the outer CV joint.
6. Remove the outer CV joint boot.
Installation
1. Install the outer CV joint boot.
2.
CAUTION: Do not damage the bearing retainer.
• NOTE: The outer CV joint is retained to the shaft by a spring clip.
Install the outer CV joint.
3. Attach the outer CV joint boot.
Install new grease.
4. NOTE: Make sure enough air is present in the CV boot.
• NOTE: Install new retaining clips.
Using a suitable tool, install the CV joint retaining clips.
5. Remove the front halfshaft from the clamp.
6. Install the front halfshaft. For additional information, refer to
Halfshaft
LH
. For additional information, refer to
Halfshaft RH
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст