Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 266
Published: 11-May-2011
Fuel Charging and Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27
- Throttle Body
Removal and Installation
Removal
All vehicles
CAUTION: Do not attempt to clean the throttle body. The bore and the throttle plate has a special coating applied during manufacture
which should not be removed.
1. Remove the air cleaner outlet pipe. For additional information, refer to
Section
303-12A Intake Air Distribution and Filtering
Section
303-12B
Intake Air Distribution and Filtering
.
Vehicles with 2.0L engine
2. Disconnect the cruise control cable.
3. Disconnect the accelerator cable.
1. Position the accelerator actuator to the open position.
2. Disconnect the accelerator cable.
4. Disconnect the electrical connector.
5. Disconnect the electrical connector.
Vehicles with 2.5L or 3.0L engine
6. Disconnect the electrical connector.
7. Disconnect the electrical connector.
8. Remove the throttle body.
Vehicles with 2.0L engine
9. Remove the throttle body.
All vehicles
10. NOTE: 2.5L and 3.0L shown, 2.0L similar.
Remove and discard the O-ring seal.
Installation
All vehicles
CAUTION: Do not attempt to clean the throttle body. The bore and the throttle plate has a special coating applied during manufacture
which should not be removed.
1. NOTE: 2.5L and 3.0L shown, 2.0L similar.
To install, reverse the removal procedure.
Install a new O-ring seal.
Vehicles with 2.5L or 3.0L engine
2. Tighten to 10 Nm.
Vehicles with 2.0L engine
3. Tighten to 10 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст