Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 118
Published: 11-May-2011
Steering Column -
Torque Specifications
Description
Nm
lb-ft
lb-in
Steering wheel retaining bolt
47
35
-
Steering column lower retaining bolt
25
18
-
Steering column retaining bolts
24
18
-
Steering column flexible coupling retaining bolt.
25
18
–
Published: 11-May-2011
Steering Column - Steering Column
Description and Operation
Item
Part Number
Description
1
—
Steering column
2
—
Steering wheel
3
—
Steering wheel angle sensor
4
—
Steering column flexible coupling
The steering column lock is secured to the upper casting of the steering column and consists of a locking pin. The steering column is locked
and unlocked by inserting and removing the ignition key respectively.
The steering column has tilt and telescope functions. These allow the driver to manually set the steering column position by using the
tilt/telescope lever, regardless of the ignition switch position. The steering column is capable of being tilted up or tilted down and
telescoped in or out, and is unlocked and locked into position using a single lever located on the underside of the steering column.
The lower part of the steering column consists of two shafts. The lower flexible coupling shaft is attached to both the steering gear and the
upper shaft.
No routine maintenance of the steering wheel is required. Any setting of steering wheel for misalignment must be achieved by adjusting the
tie rods.
Published: 11-May-2011
Steering Column - Steering Column
Diagnosis and Testing
For additional information, refer to Section
211-00 Steering System - General Information
.
Published: 11-May-2011
Steering Column - Ignition Switch Lock Cylinder
Removal and Installation
Removal
1. Remove the driver side instrument panel lower trim panel pocket.
2. Remove the drivers side instrument panel lower trim panel.
3. Remove the steering column lower shroud.
4. Remove the ignition switch lock cylinder.
Turn the ignition key to position 1.
Press the locking pin.
Remove the ignition switch lock cylinder.
Installation
1. To install, reverse the removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст