Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 43

11. Remove the wheel knuckle.

Detach the rear lower arm.

12.

CAUTION: Make sure correct position of the mounting bracket is

noted before removal.

Remove the wheel knuckle mounting bracket.

Installation

• NOTE: The final tightening of the rear suspension components must be carried out with the vehicle on its wheels.

1.

CAUTION: Make sure the mounting bracket is installed in the

correct position.

Install the wheel knuckle mounting bracket.

Tighten to 130 Nm.

2. Install the wheel knuckle.

3. Attach the wheel knuckle mounting bracket.

4. Install the front lower arm.

5. Attach the upper arm.

6. Attach the damper.

7. Attach the parking brake cable and conduit.

8. Attach the parking brake cable and conduit.

9. Attach the ABS wheel speed sensor wiring harness.

10. Install a new ABS wheel speed sensor wiring harness retaining strap.

11. Install the wheel hub.

For additional information, refer to: Wheel Hub (204-02, Removal and
Installation).

12. Tighten to 124 Nm.

13. Tighten to 124 Nm.

14. Tighten to 124 Nm.

15. Tighten to 115 Nm.

Note: If you are re-using this fixing on a vehicle built prior to VIN
J29472, then tighten to 130 Nm. If you are replacing a fixing on
any vehicle, then you must replace both nut and bolt and tighten to
115 Nm.

16. Check the wheel alignment and adjust as necessary.

For additional information, refer to:

Wheel Alignment Angles

(204-00

Suspension System - General Information, Description and Operation).