Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 251
13. Remove the retaining strap from the engine oil cooler coolant hose.
14. Install the front towing eye trims.
15. Install the air splitter grille.
Remove the protective tape from the front bumper.
16. Lower the vehicle.
17. Remove the retaining straps from the A/C condenser and radiator.
Vehicles built from VIN:E71957
18. Connect the cooling fan motor control module electrical connector.
19. Connect the upper coolant hose onto the radiator.
20. Connect the radiator vent hose onto the radiator.
Vehicles built up to VIN:E71956
21. Connect the cooling fan motor control module electrical connectors.
22. Connect the upper coolant hose onto the radiator.
23. Connect the radiator vent hose onto the radiator.
All vehicles
24. Install the air cleaner intake duct.
25. Install the air cleaner.
For additional information, refer to:
Air Cleaner
(303-12A Intake Air
Distribution and Filtering - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA
V6 - AJ27, Removal and Installation).
26. Fill the cooling system.
For additional information, refer to:
Cooling System Draining, Filling and
Bleeding
(303-03A Engine Cooling - 2.0L NA V6 - AJV6/2.5L NA V6 -
AJV6/3.0L NA V6 - AJ27, General Procedures).
27. Check and adjust the power assisted steering fluid level.
Published: 11-May-2011
Engine Cooling - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Radiator
Removal and Installation
Removal
1. Remove the cooling module. For additional information, refer to
Cooling
Module
.
2.
CAUTION: Make sure that the retaining lugs of the radiator are not
damaged when removing the cooling fan motor and shroud from the
radiator.
Remove the cooling fan motor and shroud.
Installation
1. CAUTIONS:
Make sure that the retaining lugs of the radiator are not damaged
when installing the cooling fan motor and shroud to the radiator.
The radiator isolator mountings are constructed from a special
material. Use only the correct specification radiator isolator mountings.
Inspect the radiator isolator mountings for damage and fatigue.
Install new radiator isolator mountings if required.
Inspect the radiator seals for damage and security. Install new
radiator seals if required.
To install, reverse the removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст