Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 157

29. Detach the accelerator cable.

1. Reposition the accelerator lever to the fully open position.

2. Detach the accelerator cable.

30. Detach the accelerator cable retaining bracket.

31. Detach the coolant hoses.

All vehicles

32. Detach the battery cables.

33. NOTE: Upper selector cable shown, lower selector cable similar.

Detach the selector cables.

1. Press the button.

2. Detach the selector cables.

34. NOTE: Secure the selector cables using tie straps.

Detach the selector cables.

35.

CAUTION: If brake fluid is spilt on the paintwork, the affected

area must be immediately washed down with cold water.

• NOTE: Drain the fluid into a suitable container.

• NOTE: Using a suitable blanking plug, seal the pipe and the slave
cylinder.

• NOTE: Secure the clutch slave cylinder pipe using tie straps.

Disconnect the clutch slave cylinder pipe and secure to one side.

1. Detach the clutch slave cylinder pipe from the slave cylinder.

2. Detach the clutch cylinder from the retaining bracket.

36. Disconnect the reverse light switch electrical connector.

37. Disconnect the engine harness electrical connector.

38. Using special tool 418-535, disconnect the engine control module

(ECM) electrical connector.

39. Disconnect the ground cable.

40. NOTE: Drain the fluid into a suitable container.

• NOTE: Use a suitable blanking plug to seal the hose.

Detach the power steering hose.

41. Disconnect the spring lock coupling.

For additional information, refer to:

Spring Lock Couplings

(310-00 Fuel

System - General Information, General Procedures).

42. Detach the coolant pipe.

43. NOTE: Right-hand shown, left-hand similar.

Detach the strut and spring assembly.

44. Raise the vehicle.

45. Install the special tool.

46. NOTE: Left-hand shown, right-hand similar.

Position and adjust the special tool rear height adjuster.

47. NOTE: Right-hand shown, left-hand similar.

Position and adjust the special tool front height adjuster.