Renault Magnum engine. Manual — part 6
2 / 3
Remove lip seal
(1).
Use tool 0192 + 6400.
Remove securing nuts and bolts
(1).
Remove casing
(2).
3 / 3
Tools
Specific tools
Illustration
RENAULT
TRUCKS part N°
Designation
Manufacturer's
reference N°
Manufacturer's code N°
Scale
Qty
7409990192
PULLER
2
1
7409996400
PULLER
2
1
1 / 12
Crankshaft front seal, fitting
There are
2 crankcase models:
Model
A.
Model
B.
See illustration opposite.
Model: A
If it has, it is essential to replace the seal and the crankcase.
The seal is supplied fitted to a protective ring. It is essential to hold the seal to the ring until it is finally installed in the case.Do not apply grease
to the lips.Any seal that has been removed from its ring must not be re-used.
2 / 12
Install tool 6401.
Tighten bolts to torque.
See pages .
Fit bolts
(1) in locations (A).
Use
2 headless screws (1) diameter: M8 mm, length: 50 mm.
Clean the contact faces thoroughly.
Apply a bead of sealing compound to the gearbox casing joint face.
Apply "
SILICONE 7091
".
See pages .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст